说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 句库 -> 中间下料预焙槽
1.
Aluminium electrlysis by means of low molecular ratio electrolyte is an important mark for centre-worked prebake cell at present.
采用低分子比电解质进行铝电解生产是现代中间下料预焙槽的重要标志。
2.
TECHNICAL AND ECONOMIC ANALYSIS OF THE CONVERSION FROM SODERBERG CELLS INTO THE CENTER POINT FEEDING PREBAKED CELLS IN THE SAME CAPACITY;
自焙槽改造为同级中间点式下料预焙槽的技术经济分析
3.
open prebaked anode type cell
敞开式预焙阳极电解槽
4.
Study on the Life of GL 190kA Prebaked Aluminum Reduction Cells;
GL190kA预焙铝电解槽槽寿命问题研究
5.
Lower temperature aluminium reduction practices of SY300kA pre-baked anode cell
SY300kA大型预焙电解槽在较低温度下电解生产的实践
6.
Analysis on Heat Balance Characteristics under Lower Molecular Ratio and Control for 180 kA Heavy Pre-baking Aluminum Smelting Pot
浅析180 kA大型预焙铝电解槽低分子比下的热平衡特性与控制
7.
Technique code for retrofitting soderberg cell into prebaked anode cell in aluminium smelters
自焙阳极铝电解槽预焙化改造技术规范
8.
The Development and Application of High-temperature Fume Preheating Technology on the 75kA Aluminum Reduction Cell;
高温烟气焙烧技术在75kA预焙槽上的开发应用
9.
Research on Numerical Simulation of the Multi-field during Gas Preheating and Baking Process in the Drained Aluminum Reduction Cells;
导流型铝电解槽燃气预热焙烧过程中多场数值仿真研究
10.
In-depth Characteristics Extraction of Cell Voltage Fluctuation in Aluminum Reduction Cells
大型预焙铝电解槽槽电压波动特征提取
11.
Spectral analysis of cell voltage fluctuation in 320 kA pre-baked aluminum reduction cells
320kA系列预焙铝电解槽槽电压波动的频谱解析
12.
Experimental Application of Pre-baked Slot Anode in 300 kA Aluminum Smelting Pot
预焙沟槽阳极在300kA铝电解槽上的试验与应用
13.
The Research of Fault Diagnosis System for 350kA Pre-baked Aluminum Reduction Cell;
350kA预焙铝电解槽故障诊断系统的研究
14.
The Study of the Enlarge of Current in 160KA Cell;
160KA预焙铝电解槽强化电流试验研究
15.
The Simulation of the Flow Field of 300kA Large Scale Prebaked Aluminum Electrolysis Cell
300kA预焙阳极铝电解槽流场的仿真
16.
Energy Saving Operation of 300 kA Prebaked Aluminum Smelting Pot
300kA预焙铝电解槽节能生产经验
17.
Discussion on the technology of increasing the current of large prebaked cell
大型预焙铝电解槽强化电流技术探讨
18.
The controller is applied to realize the control of pre-baked aluminium electrolytic cell temperature.
利用该控制器实现对预焙铝电解槽的温度控制。