说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 句库 -> 拉深工序
1.
The multi-stage forming optimize based on Dynaform
基于Dynaform的多次拉深工序优化设计
2.
Drawing process and design of die for car C-shaped pillar reinforcement plate
轿车C柱加强板拉深工艺与拉深模设计
3.
Research on Timing Modeling of VDSM IC Cells;
深亚微米工艺下的单元时序建模研究
4.
Experimental Investigation and Numerical Simulation of Micro Deep Drawing;
微拉深工艺的实验研究及计算机模拟
5.
The Theoretical and Experimental Research on Drawing Technology of Curved Die;
曲面凹模拉深工艺的理论与试验研究
6.
Research on Micro-Forming Process of C2680 Yellow Brass Foil;
C2680黄铜箔微圆筒拉深工艺研究
7.
The Application of DYNAFORM in the Optimization of the Drawing Process;
DYNAFORM在拉深件工艺优化上的应用
8.
A Brief Discussion on the Calculating Method of the Drawing Technique of the Wide Flange Tubby Work;
宽凸缘筒形件拉深工艺计算方法初探
9.
Study on the Deep Drawing of AZ31 Magnesium Alloy Sheet
AZ31镁合金板材拉深工艺的研究
10.
Analysis and optimization of drawing process for interior car door panel
汽车门内板拉深成形工艺分析与优化
11.
Drawing of Cold Stamping Process of Bearing Frame and Die Design
轴承架的冷冲压拉深工艺及模具设计
12.
Research on blank shape and drawing process of asymmetric box part
非对称盒形工件拉深毛坯与成形设计
13.
A New Process of Hydro-mechanical Deep Drawing for Magnesium Alloy Sheets at Gradient Temperature
镁合金板材液压梯温拉深成形新工艺
14.
Approximation Calculation of Drawing Technology of Flange Cylindrical Parts
有凸缘圆筒形件的拉深工艺计算分析
15.
CAD/CAPP/CAE system of progressive deep drawing by knowledge based engineering
基于知识工程的连续拉深CAD/CAPP/CAE系统
16.
Experimental study of hot deep drawing for twin-roll-cast AZ31 alloy
AZ31镁合金铸轧板材热拉深工艺研究
17.
FEM Simulation on New Deep Drawing Process to Blank with Technique Holes
带工艺孔的板坯拉深新工艺有限元模拟
18.
If the process of injection stretch and blow moulding are performed within one machine, the process is called one-stage.
在一台机内完成注、拉、吹工序的工艺叫一步法。