1.
The Optimization of Venting Area of Airbag Landing System
气囊着陆缓冲系统的排气孔面积优化
2.
A method for measuring area of traumatic perforation of tympanic membrane: analysis of 41 cases;
外伤性鼓膜穿孔面积测定方法及41例分析
3.
Effect of area ratio of impingement hole to effusion hole on heat transfer characteristics of impingement-effusion composite cooling
冲击-多斜孔壁复合冷却中冲击孔与多斜孔面积比对换热特性的影响
4.
Figure 5. Transfer efficiency of a solder paste related to aperture area ratio and its effect on reflowed bump co-planarity.
图5，锡高转移的效率与孔面积比率及它对回流峰共面度的影响。
5.
Changing throttle hole area has not influence on winding current,electromagnetism valve lift.
改变节流孔面积对线圈电流、电磁阀升程没有影响；
6.
injector hole area
喷嘴孔的通过截面面积
7.
Synthesis of Mesoporous Materials With Large Surface Area and Micropore Duct
具有高比表面积和微孔-介孔分子筛的合成
8.
Application of ASAP2020 specific surface area and porosity analyzer.
ASAP2020比表面积及孔隙分析仪的应用
9.
The cross-sectional areas of the pore openings vary along their length.
孔隙通道的横截面面积沿其长度方向变化。
10.
Influence of the Axle s Precision about the Centerhole s Cone area;
中心孔锥面面积对轴类零件加工精度的影响
11.
When the pad area is greater than66 percent of the aperture wall surface area, the probability of achieving efficient paste transfer is increased.
当焊盘面积大于孔壁表面积的66%提高锡膏有效转移的可能性。
12.
Characterization of the BET Surface Area, Pore Size Distribution and Intraparticle Diffusivity of Porous Materials;
多孔粉体比表面积、孔分布和内扩散系数的表征研究
13.
Uncertianty Evaluation of Measurement of Specific Surface Area and Pore Size Distribution of Porous Material
多孔材料比表面积与孔径分布测量不确定度评价
14.
The effect of the specific surface area and pore radius distribution of inorganic materials on the capacity of absorbing and desorbing moisture in the air
多孔结构无机材料比表面积和孔径分布对调湿性的影响
15.
Film cooling characteristics of converging-expanding hole with equal exit-entry area
出/入口面积相等的收缩-扩张孔气膜冷却特性
16.
Prediction model of bulk modulus reduction for porous asphalt pavement
多孔沥青路面体积模量衰变的预测模型
17.
Gas liquid mass transfer specific area in microporous membrane gas distributor
微孔膜气体分布器气液传质比表面积的研究
18.
Analytical Model for Cross-Sectional Area of Workpiece in Round-Oval-Round Pass Sequence in Bar Rolling
棒材轧制圆-椭圆-圆孔型中轧件面积计算模型