1.
Fuzzy optimal design facing cavity wall thickness of large-scale die casting mold
面向大型压铸模型腔壁厚的模糊优化设计
2.
Transmitter Shell Design for Injection Mold Wall Thickness and Static Stiffness Finite Element Analysis
探测器壳体注塑模具型腔壁厚设计及静刚度有限元分析
3.
The thickened artery wall narrows the channel through which the blood flows.
变厚的动脉壁使流通血液的管腔变细。
4.
At stabilization phase,wall-node cavity or pleura incrassation and calcification were revealed.
稳定后期表现为附壁结节空腔或胸膜增厚、钙化。
5.
both bowel-wall thickening and luminal dilatation were the early findings;
肠壁增厚和肠腔扩张、积液亦属较早期征象；
6.
Research on Oversize in the Thickness of Shell of Launcher with Pane Figure
方腔式导轨发射装置壳体壁厚尺寸超差研究
7.
FE Simulating and Technics for Forming of Large Thick Cylinder;
大型厚壁筒体成形工艺及有限元模拟
8.
Finite Element Simulation Analysis of Welded Tube Forming with Small Diameter and Thickness
小直径厚壁焊管成型有限元仿真分析
9.
Table2. Comparison of common carotid arterial IMT, D and I/ D between essential hypertensive group and control group.
表2.高血压组与对照组颈总动脉内膜－膜厚度、腔及壁/比值比较.
10.
The mechanisms were as follows:The wall of arterioles’ thicker and stenosis of arterioles lead to the worse blood supplyment of gallbladder.
(1) 胆囊血管壁明显增厚，血管腔显著狭窄，致使胆囊血供差。
11.
Study and Application on the Cast Material of Crack Resistance Gypsum Mould and Equal Wall Thickness of Cast Mould
抗裂石膏型铸造材料及铸型等壁厚研究与应用
12.
Experimental Study and Theoretical Analysis on Load Carrying Apacity of Cold-Formed Flexural Members with Thicknesses Less Than 2mm;
壁厚小于2mm冷弯薄壁型钢受弯构件承载力试验研究及理论分析
13.
Experimental study on behavior of cold-formed steel flexural members with thickness less than 2mm
壁厚2mm以下冷弯薄壁型钢受弯构件性能试验研究
14.
Sclerenchyma cells are a more common type of supporting cell.
厚壁组织细胞是一种常见的支持细胞类型。
15.
Thick wall model simulation of EDM spark locations detection
电火花加工放电位置检测厚壁模型的仿真
16.
The Analytical Solutions of Concrete Thick-walled Cylinder with a Gradient Dependent Damage Model;
混凝土厚壁筒梯度依赖损伤模型解析解
17.
Theoretical Analysis and Effect Research on Residual Stresses of Thick-Wall Cold-Formed Steel;
厚壁冷成型钢残余应力理论分析及其影响研究
18.
Simulation Analysis on Molding Product of Counterbalance Weight with Thick Wall
厚壁平衡块塑料制品的注射成型模拟分析