1.
Specification: direction of rotation of output shaft varies with that of input shaft.
说明：当输入轴旋转方向改变，输出轴相应改变。
2.
Excessive amount of grease applied to the input shaft splines.
涂抹过量黄油于输入轴齿槽中。
3.
Finite Element Analysis about the Hollow Enter Shaft in the Accelerator of Wind Generator
风电增速箱空心输入轴的有限元分析
4.
Finite Element Analysis of Hollow Input Shaft Based on Ansys 10.0
基于ansys10.0的空心输入轴有限元分析
5.
Analysis and Countermeasures of Input Shaft Breaking for Gearbox of Mine Belt Conveyor
矿用带式输送机减速器输入轴断裂分析及对策
6.
A gearing device that causes the output drive shaft to rotate at a slower rate than the engine input shaft.
低档使输出传动轴转速慢于引擎输入轴的齿轮装置
7.
Modular units for machine tool construction--Multi-spindle heads--Casing and input drive shaft dimensions
GB/T3668.1-1983组合机床通用部件多轴箱箱体和输入轴尺寸
8.
Failure Research of the Inputting Shaft for the High Speed Wire-rod Finishing Mill in Chang Gang;
长钢高速线材精轧机夹送辊输入轴断裂失效研究
9.
The input axis of the azimuth gyro under this condition is vertical, and pendulum unit is nulled.
在这样情况下方位陀螺的输入轴是处于垂直位置，同时摆锤单元在零位。
10.
Axle Input Operating Angle −7°
车轴输入工作角 −7°
11.
Research on information input method of shaft parts for CAPP system
CAPP系统轴类零件信息输入方法的研究
12.
pto bearing support
动力输出轴支持轴承
13.
conveyer screw shaft coupling
输送机螺旋轴联轴节
14.
The input signal of the system was filtrated through the line-shaft, and easy to be followed by the units.
由于输入信号经过总轴作用并过滤,易于单元驱动器跟踪。
15.
Computing the input impedance of coax-fed microstrip patch antennas by the two-level discrete complex image method
采用二级离散复镜像法分析同轴馈电微带天线的输入阻抗
16.
The feed holes for the crankshaft main bearings.
曲轴主轴承进入口。
17.
Agricultural tractors and machinery-Power take-off drive shafts and position of power-input connection
GB/T17126-1997农业拖拉机和机械动力输出万向节传动轴和动力输入连接装置的位置
18.
The handle inputs rotation upon the wheel, then transmitted to another shaft by the belt transmission mechanism.
加上皮带传动机构，手把输入旋转运动于转轮，用皮带传输转动另一个轴。