1.
Study on the Welding Wire Used in Repairing ZL205A Alloy Castings;
ZL205A铝合金铸件焊补用焊丝的研究
2.
CO_2+O_2 Mixed GMAW Welding Gray Cast Iron
CO_2+O_2混合气体保护焊补焊灰铸铁
3.
The Welding Experimentation of 12Cr1MoVG Tube Platen and Analysis of Manual Arc Welding Cracks
膜式窄节距12Cr1MoVG管屏埋弧焊接试验及手工电弧焊补焊裂纹分析
4.
Causes and preventive measures for soledering cracks on bearing surface of adapter
承载鞍支承面焊补裂纹的形成原因及防止措施
5.
Study on Optimized for Welding Process of the Crack in High-pressured Cylinder of Steam Turbine
汽轮机高压缸体裂纹焊补工艺优化研究
6.
Microstructure and Improvement Measures of Railway Wagon Side Frame after Repair Welding
铁路货车侧架焊补后的组织缺陷及改善措施
7.
The crack between the coped and hole was removed by air arc and then repaired by welding.
在修割边和钻孔之间的裂纹用气弧消除，然后进行焊补。
8.
After weld repairs, however, the overall quality and reliability of a cast valve is difficult to determine.
但是，在焊补后，铸件阀门的整体质量和可靠性就变得难于保证。
9.
Ceramic Cushion of Steel Pipe Weld Aided Device and Its Welding Procedure
钢管焊缝陶瓷垫补焊装置及焊接工艺
10.
welded reinforcement of nozzle opening
接管开孔的焊接补强
11.
Study on High Efficient Bonding and Repaired Welding Process of TA15 Titanium Alloy;
TA15钛合金高效焊接及补焊工艺研究
12.
Analysis and Patching for Cracks which Appeared after the 2000m~3 Spherical Tank Assembling Weld
2000m~3球罐组焊裂纹分析与修补
13.
Real-time Interpolation Algorithm for Trajectory Planning Based on Welding Robot
基于焊接机器人的实时轨迹插补算法
14.
Welding Process for 2A12-T4 of Aluminum Alloy
铝合金2A12-T4壳体零件补焊工艺
15.
5CrNiMo Die Forging Welding Technology
5CrNiMo锤锻模具补焊工艺方法
16.
Specially suitable for zinc patching of weld seam in tube welding line, and capacitor spray.
本套设备适合于高频焊管生产线上进行焊缝的补锌及电容喷涂。
17.
Automatic offset function for long cable up to 100m.
具有焊线长的自动补偿功能，焊接电缆可长至100米.
18.
Residual stress analysis of repair welding at different zone of Q345R welded joint based on finite element simulation
Q345R钢焊接接头不同部位补焊残余应力的有限元分析