1.
Method of Selecting Whetstone for Superfinishing of Bearing Parts
轴承零件超精加工中油石的选用方法
2.
Shaft Assembly (Male, female, washer, grease….
轴组件（轴，轴套，轴承，油脂。。。）
3.
Bolt( screw, nut, stud, spring washer, pin, ball bearing, roller bearing) is the most commonly used machine part.
螺栓（钉、帽、头螺栓、簧垫圈、、珠轴承、柱轴承）最常用的机械零件。
4.
Ball bearings, and sometimes automotive parts, are designed on the basis of finite life.
球轴承和汽车零件有时是按无限寿命设计的。
5.
This oil thereby reaches the various bearings that support rotating shafts and the different moving parts in the engine.
被输送到发动机的曲轴和各种运动零件的每个轴承上。
6.
Using it to spray on axes and bore of bearing.
运用粉末复合电弧喷涂技术对轴类零件和轴承座内孔进行喷涂。
7.
Install axle shaft bearing with Installer 6436 and Handle C–417Ensure part number on the bearing is against the installer.
用安装工具6436和手柄C–4171安装车轴轴承。确保轴承上的零件号对着安装工具。
8.
377 bolt (screw, nut, stud, spring washer, pin, ball bearing, roller bearing) is the most commonly used machine part.
螺栓（螺钉、螺帽、双头螺栓、弹簧垫圈、销、滚珠轴承、滚柱轴承）是最常用的机械零件。
9.
"Each Ball Bearing has three main parts: two grooved, ringlike races and a number of Balls."
球轴承有三个主要零件,即两个带有沟槽的套圈和许多球。
10.
Automobile and motorcycle spare parts, crankshafts, connecting rods, shafts, power steering shafts.
汽机车零件–轴、杆、轴及动力方向盘轴心.
11.
having identical parts on each side of an axis.
轴的双边有互换零件的。
12.
Rolling bearings accessories--Plummer block housings--Boundary dimensions
GB/T7813-1998滚动轴承附件轴承座外形尺寸
13.
any of various shafts that rotate or serve as axes for larger rotating parts.
作为大的旋转零件的轴的各种轴。
14.
roll-chock washing machine
轧辊轴承部件清洗装置
15.
chamfered edge (for the bitting)
(宝石轴承元件的)装入棱
16.
Hub And Bearing Assembly Mounting Surfaces
轮毂轴承组件固定面
17.
Powder metallurgy plain bearing--Technical requirements
GB/T2688-1981滑动轴承粉末冶金轴承技术条件
18.
Axial symmetry parts are applied abroad, it is important to research extruding deformation of axial symmetry parts.
轴对称零件是最广泛应用的零件之一,因此研究轴对称零件的挤压过程有着重要的现实意义。