1.
Application Example and Design for Sliding Core-Pulling Structure With Undercut
带倒勾滑块抽芯结构设计及应用实例
2.
Core-Pulling Structural Analysis and Hydraulic Core-Pulling Design for Bushing-Type Parts Die-Casting Die
衬套类零件压铸模抽芯结构分析及其液压抽芯设计
3.
Application of Half Sliding Block in Outer Side Core-Pulling Mechanism
哈夫滑块在外侧抽芯结构中的系列应用
4.
The Reconstruction of Injection Molding Machine for the Trial of a Mould with Complicated Core-Pulling Mechanism
复杂箱体抽芯结构模具试模过程中对注塑机的改造
5.
The contractile interior core pulling mould structure was designed for the molding of the concave part of inner side of outer casing of flow meter.
为成型流量计外壳内侧凹进部分,设计了收缩内抽芯模具结构。
6.
Research on Core Pulling Technology of Die Casting Die with Crossed Core Structure
采用交叉型芯机构的压铸模抽芯工艺的研究
7.
Calculating the Taking out Force in the Plastic Injection Mould;
塑料注射模斜导柱抽芯机构中抽拔力的计算
8.
An Application of PTFE Adhesive Film as a Lubricant of Core-Drawn Rivet
聚四氟乙烯粘结膜作抽芯铆钉润滑剂
9.
stripper mechanism
脱锭机构；芯棒抽出机构；(卷取机的)卸卷机构
10.
DESIGN OF INJECTION MOULD WITH MECHANISM SET INSIDE CORE-PULLING SLIDE PREVENTING PLASTIC PARTS FROM ADHERING TO MOULD
抽芯滑块内嵌防粘模机构的注射模设计
11.
architecture for extended abstract data flow
扩充的抽象数据流结构
12.
Research on Knowledge Base and Reasoning System of Injection Mold's Side Action;
注塑模具侧向分型与抽芯机构知识库与推理机的研究
13.
Study and Optimization of Automobile Bumper Made of Structure Filled with Aluminum Foam;
泡沫铝夹芯结构汽车保险杠的研究及结构优化
14.
Idea of “Three Parts” Electricity Tariff Structure for Pumped-storage Plant;
抽水蓄能电站“三部制”电价结构的构想
15.
Its moving iron core transformer structure is most widely used.
动铁芯式变压器结构，应用最广。
16.
Figure 2 illustrates the fundamental aspects of a die bond.
图2所示为管芯连接的基本结构。
17.
Numerical Simulation of Hollow-Core Fibers with Cobweb Cladding Structer;
蜘蛛网包层结构空芯光纤的数值模拟
18.
A Clustering Algorithm According to Sequence,Structure and Microarray Data;
基于序列、结构和芯片数据的聚类算法