1.
Research on Reliability Technology for Main Shaft Bearings of Aircraft Engine;
航空发动机主轴轴承可靠性技术研究
2.
The Methods of Increasing the Life of the Plastic Cracker Mainshaft Bearings;
提高塑料破碎机主轴轴承寿命的措施
3.
upper center crankshaft bearing
曲轴主轴承上中轴瓦
4.
The feed holes for the crankshaft main bearings.
曲轴主轴承进入口。
5.
Crankshaft and main bearings service
曲轴和主轴承的维修
6.
Install the lower bearing inserts into the main bearing caps.
安装下轴瓦到主轴承盖。
7.
The Model Analysis of the Ceramic Bearing Electric Spindle;
陶瓷轴承电主轴主轴的振动模态分析
8.
Undersize crankshaft main bearing journals.
尺寸小于标准的凸轮轴主轴承轴颈。
9.
These are the same as those used for the main bearings.
这些轴承与那些被用作主要轴承的轴承相同。
10.
Shaft Assembly (Male, female, washer, grease….
轴组件（轴，轴套，轴承，油脂。。。）
11.
Remove thrust bearings from rear main bearing carrier.
从后主轴承托架上拆下止推轴承。
12.
Modeling for Rotor System of AC Magnetic Bearing Electric Spindle;
交流磁轴承支承电主轴转子系统建模
13.
Analytical Investigation on Strength and Main Bearing Lubrication of CA4D32 Diesel Engine Crankshaft System Based on a Simulation Technique;
柴油机曲轴轴系强度和主轴承润滑仿真研究
14.
Bearing Clearance (#1 Journal)
轴承间隙（#1轴颈）
15.
main bearing aligning gauge
主轴承座孔同轴度检验仪
16.
MAIN BEARING JOURNAL DIAMETER (CRANKSHAFT REMOVED)
主轴承颈部直径（曲轴已卸去）
17.
Fatigue Life Estimation of Main Shaft Ball Bearing for High-Speed AeroEngine;
航空发动机主轴球轴承疲劳寿命估算
18.
main drive gear bearing oil slinger
主动齿轮轴承抛油环