1.
Study and Application of Hot Extrusion Process for Boss Quill
汽车轮毂轴管复合热挤压工艺的研究与应用
2.
Moment Rigidity Analysis on Flange of Automotive Hub Bearings
轿车轮毂轴承轮毂凸缘力矩刚性分析
3.
SMALLER DIAMETER OF PIVOT BEARING
轮毂轴承的较小直径端
4.
wheel hub bearing adjusting nut
车轮毂轴承调整螺母
5.
Install rotor on axle hub.
在车轴轮毂上安装转子。
6.
Hub And Bearing Assembly Mounting Surfaces
轮毂轴承组件固定面
7.
Front Stub Axle To Hub Bearing Nut
前螺桩轴至轮毂轴承螺帽
8.
"The wheels were made like carriage-wheels, the rods on which they were fixed, the parts forming their edges, their rods and the middle points of them, were all formed out of liquid metal."
轮的样式如同车轮。轴，辋，辐，毂都是铸的。
9.
A slot for a key in the hub or shaft of a wheel.
键槽轮子的毂或轴里的键的沟槽
10.
Shafts and hubs are usually fastened together by means of keys.
轴和轮毂通常用键固定在一起。
11.
Analysis of the Calculation and the Modes of Break-down of Automobile Hub Bearing
汽车轮毂轴承的计算及失效形式分析
12.
Contact analysis of MW wind turbine hub and bearing bolt connection
风力机轮毂和轴承螺栓联接接触分析
13.
An enlarged part of a shaft to which another shaft is coupled or to which a wheel or gear is keyed.
轮毂一轴与另一轴耦合处或一轴与机轮或齿轮楔合处的增大部分
14.
If the axle shaft and hub bearing are being removed in order to service another component, the axle shaft and hub bearing can be removed as an assembly.
如果维修时需拆卸主动轴和轮毂轴承，主动轴和轮毂轴承可作为一个总成加以拆卸。
15.
The hub and bearing assembly does not require removal from the steering knuckle to replace wheel attaching studs in the hub and bearing assembly.
更换轮毂及轴承组件内的车轮固定螺桩无需自转向关节中取出轮毂及轴承组件。
16.
The Process Engineering and Numerical Simulation on Precision of Hub Unit Bearing;
轿车轮毂轴承单元精锻工艺设计及数值模拟
17.
Study on Modeling Technique and Improving Reliability of Automobile Hub-Bearing
汽车轮毂轴承的可靠性建模与试验技术研究
18.
Modeling & Numerical Simulation of Fatigue Life of Hub Bearing Based on Multi-Bench Test Load
轮毂轴承多工况疲劳寿命建模与数值仿真