1.
This method depends on determining the change in stress distribution within the model when it is turned upside down.
倒置法的依据是在模型倒置时测定模型内应力分布的变化。
2.
The investigation of the distribution of stress inside a cutting tool in the chip flow plane during oblique cutting (II)
斜角切削切削刀具流屑平面内应力分布的实验研究(Ⅱ)
3.
Stress Distribution in Bone Around New Dental Implant Studied by Three-dimensional Finite Element Analysis;
新型牙种植体周围骨内应力分布的三维有限元研究
4.
Distribution and 3-D Reconstruction of Intrathoracic Stress in the Swine Chest Subjected to Impact;
准静态撞击下猪胸腔内应力分布及其三维重现与肺损伤
5.
Internal Forces Redistribution and Stresses Redistribution Analysis of Continuous and Prestressed Concrete Girder Bridges
预应力混凝土连续组合梁桥的内力重分布与应力重分布分析
6.
INTERNAL FORCE REDISTRIBUTION AND CRACK CONTROL OF PRESTRESSED CONCRETE FLAT-FLOORS
预应力平板结构的内力重分布和裂缝控制
7.
Study on Secondary Internal Force and Redistribution of Internal Force about Two-span Prestressed Concrete Frame;
两跨预应力混凝土框架次内力及内力重分布规律研究
8.
Numerical Simulation Analysis of Inner Stress Field Distribution in Tungsten Matrix Composites
钨基复合材料内部应力场分布的数值模拟分析
9.
Study on the Stress Distribution of Cold Extrusion Die under Inner Pressure
冷挤压模受内压作用应力分布规律的研究
10.
Impact of Bone Graft in Intervertebral Slot on the Strain Distribution of Lumbar Internal Fixators Rod;
椎间植骨对腰椎内固定棒应力分布的影响
11.
Study on Internal Force Redistribution and Moment Modification in Prestressed Concrete Frame;
预应力混凝土框架塑性内力重分布与弯矩调幅的研究
12.
Analysis Redistribution of Internal Force of Prestressed Frames in Vertical Loads;
跨间竖向荷载作用下预应力框架内力重分布的试验研究
13.
Research into Secondary Moment and Redistribution of Internal Force about Bonded Post-Tensioned Prestressed Concrete Frame;
后张有粘结预应力混凝土框架次弯矩及内力重分布的研究
14.
Study on Secondary Moment and Redistribution of Internal Force about Continus Prestressing Concrete Hollow-core Slabs with Cold-drawn Low Carbon Wires
冷拔丝预应力砼连续多孔板的次弯矩及内力重分布研究
15.
Calculating Model and Numerical Simulation of Stress-strain Distribution of Wires Within Strands
钢丝绳股内钢丝应力—应变分布的计算模型及数值模拟
16.
3D dimensional definite analysis of stress distribution in periodontal tissue using compound retraction arch in retraction of anterior teeth
复合转矩弓丝在内收前牙时牙周组织应力分布三维有限元分析
17.
Large food items should be left inside the oven for an additional10-20 minutes after cooking to ensure even distribution of heat.
大件食物于烹煮后，应放置炉内10至20分钟，让热力均匀散布。
18.
By assuming displacement field or stress patterns within as element, it is possible.
借假设一单元内的位移状态和应力分布式，这是可能的。