1.
NC machining nut with large lead and 3-start rectangular thread
大导程三头矩形螺纹螺母的数控加工
2.
Torque Test of Thread Fastener for Automotive Braking Pipe Line
汽车制动管路螺纹紧固件的扭矩试验
3.
spiral contrapper knitting machine
螺旋形花纹吊线织袜机
4.
special taper thread tap for gas cylinder
气瓶专用锥形螺纹丝锥
5.
Metric trapezoidal screw threads-Profile
GB/T5796.1-1986梯形螺纹牙型
6.
Side view of wing screw with adjustable thread length.
螺纹长度可调整的翼形螺钉的侧面图。
7.
Standard joint is a circular male and female configuration with a corrugated metal gasket.
标准连接是圆形外螺纹和内螺纹结构，配置波纹金属垫圈。
8.
Study on factors to influence torque strength of anaerobic thread-locking adhesives for automobiles
汽车用厌氧螺纹锁固胶扭矩的影响因素研究
9.
Note that it is stretched/squashed to fit the rectangle.
注意纹理会被拉伸和缩短以适合矩形。
10.
Investigation on Heat Transfer and Flow Performance of Rectangle Channel with Riblets Groove;
矩形条纹槽道传热和流动特性的研究
11.
STRESS INTENSITY EVALUATION FORMULAS FOR A RECTANGULAR INTERFACIAL CRACK IN THREE DIMENSIONAL BIMATERIALS
矩形界面裂纹应力强度因子评价公式
12.
Spiral and decreasing sharply in diameter from base to apex.Used especially of shells.
陀螺形的螺旋形的螺纹从基部到顶端逐步递减的，尤其用于贝壳
13.
Top view of wing screw. Selection box represents thread diameter.
翼形螺钉的俯视图。选择框代表螺纹直径。
14.
Top view of wing nut. Selection box represents thread diameter.
翼形螺母的俯视图。选择框代表螺纹直径。
15.
Side view of wing nut. Selection box height represents thread diameter.
翼形螺母的侧面图。选择框高度代表螺纹直径。
16.
Beneath the handwheel is a hexheaded externally-threaded diaphragm-retaining nut.
手轮下面是一个六角形外螺纹横膈膜止动螺母。
17.
Buttress threads with 3 and 30 degrees flank angle-General pla
GB/T13576.2-1992锯齿形(3°、30°)螺纹直径与螺距系列
18.
The circular male and female bonnet joint is self-aligning and encapsulates the gasket.
圆形外螺纹和内螺纹阀盖连接是自行对准调整并且封装的垫圈。