1.
Measure of Melt Surface Characteristic and Research for Its Effect in Filling Flow Process of Micro Injection Molding
高聚物熔体表面特性测试及对微注塑影响研究
2.
The Research of Self-Assembly of Block Copolymers Melt;
嵌段共聚物高分子熔融体自组装的研究
3.
RHEOLOGICAL AND CRYSTALLIZATION BEHAVIOR OF HDPE/POLYSILOXANE MELTS
高密度聚乙烯/聚硅氧烷共混物熔体流变特性与结晶行为
4.
THE FLOW ANALYSIS OF POLYMER MELT IN CO-EXTRUSION DIE
共挤出机头中的聚合物熔体流动分析
5.
A STUDY OF RHEOLOGICAL PROPERTIES OF MOLTEN POLYETHYLENE TEREPHTHALATE--Part Ⅱ:Rheological Properties of PET Melt at High Shear Rate
聚酯熔体流变性能的研究——高剪切速率下熔体的流变性能
6.
refractory compound
难熔［高熔点］化合物
7.
Calculation of the Number of Striations of Polymer Melt for Pin Mixing Screw
聚合物熔体在销钉混合型螺杆中的分流数计算
8.
Melt Strength of Cable Compounds and Its Effects on Extrusion Process
线缆聚合物熔体强度及其对挤塑的影响
9.
Phenomenological Studies on Extrusion Swell of Polymer Melt Through Conical Short Dies;
聚合物熔体在圆锥短口模的挤出胀大唯象研究
10.
Research and Development of the Polymer Melt Pump with the Transporting System;
聚合物熔体泵及其输运系统的研制与开发
11.
The Study of Level Set Method for the Flow Filling Process in the Mold of Polymer;
聚合物成型中熔体充填过程的Level Set方法研究
12.
Research of Polymer Melt Transfer Process by Vibrating Based on Synergetics
基于协同学的聚合物熔体脉振传递过程研究
13.
Development of Extensional Viscosity of Polymer Melts or Solutions
聚合物熔体或溶液拉伸黏度的研究状况
14.
Research on High-Melt-Strength Polypropylene Via Solid Phase Grafting;
固相接枝法制备高熔体强度聚丙烯的研究
15.
Preparation of High Melt Strength Polypropylene by ～(60)Co-γ Radiation;
～（60）Co-γ辐照改性法制备高熔体强度聚丙烯
16.
Application of High Viscosity PET Melt Heat Exchanger in Direct Spinning
高黏度聚酯熔体热交换器在直纺中的应用
17.
A Study on Phase-mixing of Poly(∈-caprolactone)/Poly(vinyl chloride)after the Melting of Crystals
聚已内酯/聚氯乙烯共混物晶体熔化后相混合情况
18.
Study of Injection Behavior of Polymer Melt and Properties and Morphology of Specimen under Vibration Injection Molding;
聚合物熔体在振动场中注塑行为和试样性能与凝聚态结构的研究