1.
Their preform moulds could be 2-cavity based and use a hot plate or hot runner design.
模具有用两腔的，采用热板/热流道设计。
2.
The Flow Channel Design and Rock Breaking Characters of Suction Pulse Jet;
负压脉冲射流流道设计及破岩特点研究
3.
The Flow Passage Design and Type Selection of Pit Type Tubular Turbine
竖井贯流式机组的流道设计及选型优化探讨
4.
Internal flow Road evenly reasonable design, distribute streaming delicate.
内部流道均匀设计合理，分流细腻。
5.
design discharge of irrigation canal;normal flow of irrigation canal
灌溉渠道设计流量（正常流量）
6.
Analyze on the Urban Flood Channel Peak Discharge
城区排洪河道设计流量计算方法研究
7.
The Study on Design of Stack Mold with Hot Runner System and Its Functions;
叠式热流道模具设计及其功能的研究
8.
Research on the Optimum Design of Flow Channel in the Dynamic Curved Plane Skimmer;
动态曲面式撇油器流道优化设计研究
9.
Design of Sixteen-Channel Constant Current LED Driver
十六通道恒流LED驱动芯片的设计
10.
The design on hot runner control system based on single-chip
应用单片机的热流道控制系统的设计
11.
Orbit Design for Satellite Kuafu-A Based on Invariant Manifolds
基于不变流形的夸父卫星A轨道设计
12.
Parametric Design and Flow Field Analysis of Pipe Die for Extrusion;
管材挤出机头流道参数化设计及流场分析
13.
The Design and Selection of Chinese Distribution Organizations and Distribution Channels in the New Century;
我国流通组织和流通渠道的设计与选择
14.
Research and Design of Intelligent Drainage Device for Stray Current in Pipelines
管道杂散电流智能排流装置的研究与设计
15.
Geometry Design and Calculation of a Novel Multi-flow Channel Sheeting Die
一新型多流道片材机头的几何设计及计算方法
16.
An Approach to the Computational Methods in Calculating the Design Flow in Direct Drinking Water Pipeline;
建筑直饮水管道设计秒流量计算方法研究
17.
Study of Determination of Design Flow for Building Interior Drainage;
建筑内部排水管道设计秒流量计算方法研究
18.
Multi-cavity preform moulds do not use the cold runner design. An often-used design for the runners is hot plate design.
多腔的瓶坯模具都不采用冷流道的。较简单的流道是热板设计。