1.
Strength Analysis of Pressure and Torsion Combination Loads of Flapper Teeth of LTC
螺杆钻具瓣形万向轴瓣齿压扭组合强度分析
2.
two -joint inboard slip drive shaft
两万向节滑动的传动轴
3.
flange crossing-transmission shaft universal joint
凸缘叉-传动轴万向节
4.
Gyroscope gimbal bearings are nearly static, affording little relative motion for EHD film formation.
万向节轴承几乎是静态的，只能提供一点形成EHD油膜的运动条件。
5.
"The driving shaft causes the spider to rotate, and the other two trunnions of the spider cause the driven shaft to rotate."
主动轴使万向节十字轴转动,另外两个万向节十字头使从动轴转动。
6.
"When the two shafts are at an angle to each other, the bearings in the yokes permit the yokes to swing around on the trunnions with each revolution."
当两轴相互处在同一角度上,主动轴转动时万向节叉上的轴承使万向节叉绕万向节十字轴摆动。
7.
plunging constant velocity joint
可轴向移动的球笼式万向节
8.
An Analysis on Driving System for High Speed Motor Car Bogies with Cardan Shaft
万向轴式动力车转向架驱动系统分析
9.
"The four arms of the spider, known as trunnions, are assembled into bearings in the ends of the two shaft yokes."
万向节十字轴的四个轴颈叫做万向节十字头,分别装在两个万向节叉顶端的轴承中。
10.
Remove the universal joint strap bolts at the pinion shaft yoke.
在小齿轮轴轴轭处拆卸万向节扣夹螺栓。
11.
Failure Analysis and Structure Improvement for the Cardan Joint
十字轴万向联轴器的失效分析和结构改进
12.
An analysis for partial damage cau-ses of cross shaft journal of auto-mobile universal joint
汽车万向节十字轴轴颈局部损坏原因分析
13.
Contact problems for needle bearing of cardan shaft in high speed EMUs
高速动车组万向轴滚针轴承接触问题研究
14.
The Research on Equal-strength Design of Large-scale Heavy-load Cross-shaft Universal Clutch
大型重载十字轴式万向联轴器等强度设计研究
15.
steering worm sector bearing
转向器扇形蜗轮轴承
16.
two joint onboard slip drive shaft
两万向节外侧滑动传动轴
17.
Separate the rear universal joint from the transfer case yoke.
从传动箱轴轭上拆下后万向节。
18.
clutch and shaft coupling (including universal joints)
离合器及联轴节（包括万向节）