1.
Processing of locating holes in dies based on Cimatron software
基于Cimatron软件的模具定位孔加工
2.
Boring operations are performed to enlarge, finish, and accurately locate holes.
镗削用来扩大、精加工和加工精确定位孔。
3.
Register punch: Precision punching device used in a punch register system.
定位打孔机:应用于打孔定位系统内的精密打孔机。
4.
Punching is done with a special punch-register device.
打孔是用一种专用的打孔定位装置进行的。
5.
The theoretic problem of calculation of workpiece Orientation error when round orifices are oriented;
工件以圆孔定位时定位误差计算的理论问题
6.
Anchor/support bolt holes are located in base of body.
固定器/支架螺栓孔位于阀门的基座。
7.
Research on the Target Location of Space-borne Synthetic Aperture Radar Image;
星载合成孔径雷达图像目标定位研究
8.
Study on axial vibration drilling to improve positioning accuracy
轴向振动钻削提高钻孔定位精度研究
9.
Design of Locator for Drilling Hole Based on ARM Embedded System
基于ARM嵌入式系统的钻孔定位仪设计
10.
Register pins: Pins which locate in holes made by a punch in a punch register system.
定位圆钉:应用于打孔定位系统内的圆钉，它套入由打孔机打出的孔洞。
11.
Punch register system: Device which punches registered holes in sets of films or plates for positioning purposes.
打孔定位系统:在一套菲林片或版片上打定位小孔，以确定位置的装置。
12.
Each datum, location pins, the number of the clamp sequence, check pin's name, the value of gap and tolerance need mark on checking fixture.
定位面，定位销，夹紧顺序，孔位测量销，模拟块偏置值及公差需有标识。
13.
Judgement of accurate position and rotational angle of pupil in videonystagmogram
视频眼震图中的瞳孔定位与转角测定方法
14.
It consists of determining the ge ometry position of holes in integrated block and checking the interference betwe en one hole and the other.
它包括集成块上孔道几何位置的确定和孔道之间的干涉校核。
15.
This machine is equipped with Korean made CCD camera for pin point positioning.
此十字定位打孔机利用韩制高倍率ccd镜头来进行定位.
16.
An Automatic Approach to Evaluate Locating Plan for Dowel-pin Modular Fixture System;
孔系组合夹具定位方案定位质量评价方法的研究
17.
Identification the Loci for Porokeratosis Palmaris Plantaris et Disseminata and Disseminated Superficial Porokeratosis and Cloning the Gene of Disseminated Superficial Porokeratosis;
掌跖合并播散性汗孔角化症基因定位和播散性浅表性汗孔角化症基因定位克隆研究
18.
When it has been decided where we are going to drill, we put up at the surface an oil derrick.
决定了钻孔位置后，我们就在地面上竖起井架。