1.
Study on the influence of water-rock interaction to the strength of sandstone
水岩相互作用对砂岩单轴强度的影响研究
2.
Three-parameter Generalized Failure Criteria Based on Tension,Compression and Shear Uniaxial Strength
基于拉伸、压缩、剪切单轴强度试验值的材料三参数广义强度准则
3.
Experimental Study on Dynamic Strength and Deformation of Concrete Under Uniaxial and Blaxial Action;
混凝土单轴、双轴动态强度和变形试验研究
4.
Uniaxial compressive strength of saturated frozen clay at constant strain rate
饱和冻结黏土在常应变率下的单轴抗压强度
5.
Experimental Study on Instantaneous Uni-axial Compressive Strength of Frozen Clay at Low Temperature
冻结黏土低温瞬时单轴抗压强度试验研究
6.
Effects of specimen-preparing methods on tensile strength of remolded loess
制样方法对重塑黄土单轴抗拉强度影响的初探
7.
Analysis of rock-socketed pile uniaxial compressive strength and bearing capacity of pile tip at three dimensional effects
嵌岩桩单轴抗压强度和三维作用下桩端承载力
8.
It is pointed that75℃ and200℃ are the threshold temperatures of elastic modulus and uniaxial compression strength respectively.
指出了75℃200℃别是花岗岩弹性模量和单轴抗压强度的门槛温度。
9.
Effects of Temperature and Strain Rate on Uniaxial Compressive Strength of Natural Fresh Water Ice
天然淡水冰单轴压缩强度及其温度和应变率效应
10.
Study of relationship between uniaxial compressive strength and electrical resistivity of frozen soil under different temperatures
不同温度下冻土单轴抗压强度与电阻率关系研究
11.
The Strain-rate Sensitivity of Strength of Bohai Sea One-Year Ice under Uniaxial Compression
渤海东部一年冰单轴压缩强度的应变速率敏感性
12.
uniaxial stress and temperature cycling test
单轴应力-温度循环试验
13.
angle of twist per unit length of shaft
轴的单位长度扭转角
14.
Optimization Design of Bearing for Internal Combustion Engine Considering Crankshaft Strength;
计及曲轴强度的内燃机轴承优化设计
15.
Analytical Investigation on Strength and Main Bearing Lubrication of CA4D32 Diesel Engine Crankshaft System Based on a Simulation Technique;
柴油机曲轴轴系强度和主轴承润滑仿真研究
16.
Coupling Research on Tribology, Stiffness and Strength of Crankshaft-bearing System;
曲轴—轴承系统摩擦学、刚度和强度的耦合研究
17.
Introduction to Single Cross Axle--A Forced Aiming Apparatus for CPⅢ Measurements
CPⅢ测量强制对中装置—单横轴介绍
18.
RUGGEDNESS. Automotive ring gear differential. Axle shafts on roller bearings.
强度：自动差速齿轮，滚子轴承上的刚性车轴。