1.
tightening bolt
拉紧螺栓，(铁)风口拉杆
2.
top link adjustment
(悬挂机构的) 上拉杆调节
3.
emergency support
车底制动拉杆安全托
4.
hood hinge rod bracket
机罩的铰链拉杆支架
5.
extensible link servo
可伸缩拉杆伺服机构
6.
steering drag link rear end grease fitting
转向纵拉杆后端油嘴
7.
steering knuckle tie rod end pressure lubricator
转向节横拉杆接头油嘴
8.
Front cable not secured to lever
前钢索不确保连到拉杆
9.
level(l) ing box
悬挂装置斜拉杆调节器
10.
Remove the nut and bolt attaching the track bar to the track bar mount on the body of the vehiclRemove the track bar from the track bar mount.
拆卸接合横拉杆与位于车身之横拉杆固定座的螺帽与螺栓。将横拉杆自横拉杆固定座拆卸下来。
11.
LOWER TRACK BAR BOLT INSTALLATION
下横拉杆螺栓的安装
12.
Failure Analysis of 30Cr2Ni2Mo Rod
30Cr2Ni2Mo拉杆断裂失效分析
13.
Strut-and-tie Model of Deep Beam Design Under Uniform Distributed Loads
均布荷载下深梁设计的压杆-拉杆模型
14.
Position lever assembly on floorpan and install lever mounting bolts.
将拉杆组合放置到底板上并安装拉杆固定螺栓。
15.
Design of Reinforced Concrete Deep Beam Based on Strut-and-tie Model;
钢筋混凝土深梁基于压杆—拉杆模型的设计
16.
The track bar connects the rear axle to the frame/body of the vehiclThe track bar is isolated from the body of the vehicle by an isloator bushing located in each end of the track bar.
横拉杆把后轴联结到车框或车体上。横拉杆用一安放在横拉杆两端的隔离衬套与车体隔离开。
17.
steering knuckle tie rod end assy
转向关节横拉杆接头总成; 转向节横拉杆接头总成
18.
The linkage may consist of a series of interconnected levers and rods, or levers and a cable.
相连部分由一系列相关的拉杆和轴或拉杆和链索所组成。