1.
Studies on Inversion of Injection Velocity in Injection Molding Based on CAE Technology;
基于CAE技术的注塑模注射速率反演研究
2.
An Experimental Study about Contrast Medium Injection Rate and Dose in Cerebral CT Perfusion Imaging;
脑CT灌注成像对比剂注射速率与剂量实验研究
3.
The scan cover, injection rate and reconstruction matrix were assured.
确定增强扫描范围、佳注射速率与重建矩阵。
4.
The flow balance in the sub-runner of mould is sensitive to injection rate of plastics melt.
结果表明,注射速率对流道平衡问题是非常敏感的。
5.
The insulin-dosage rate is set in the electronic controller according to the patient's needs.
胰岛素的剂量注射速率，可根据病人的需要在电子控制器中预先制定。
6.
Contrast Quantity and Injection Velocity in Cerebral Angiography with 64 Multi-Detector CT
多层螺旋CT脑血管成像中适当降低对比剂浓度和注射速率观察及探讨
7.
Comparison of the Safety and Effectiveness of Intravenous Metoprolol Versus Cedilanid in the Management of Rapid Ventricular Rate in Atrial Fibrillation;
静脉注射倍他乐克和西地兰控制快速房颤心室率的疗效对比观察
8.
radiation-enhanced burning rate
辐射增强的燃烧速率
9.
the rate of flow of radiant energy (electromagnetic waves).
辐射能流动速率（电磁波）。
10.
Injection System Control Analysis and Simulation Study of Ultra High Speed Injection Machine
超高速注射机注射控制的系统分析与仿真研究
11.
The Research on High Power and High Speed Transmitter of the Free Space Laser Communication;
高功率高速率FSLC发射单元的研究
12.
Note that the words "velocity"and "speed"require explanation.
请注意，“速度”和“速率”这两个词需要解释。
13.
Less reflective than ice, water absorbs more solar rays, speeding the thaw and channeling meltwater into seals' breathing holes.
比冰的反射率小，海水吸收了更多的阳光，加速了融化并使融化后的淡水注入这些通气孔。
14.
Deposition rate is increase quickly with sputtering power.
结果表明溅射功率对沉积速率的影响最大，随溅射功率的增大沉积速率快速增大。
15.
Study on FI Fast Determination of Chemical Oxygen Demand;
流动注射快速测定化学耗氧量的研究
16.
Rapid Manufacturing of Hard Injection Mould Based on RP and CAE Technology
基于RP和CAE的注射硬模快速制造技术
17.
Model Prediction Iterative Learning Control of Ram Velocity for Injection Molding Machines
注塑机注射速度的模型预测迭代学习控制
18.
Injection Velocity Control in Injection Molding by Iterative Learning Control with Zero-phase Filtering
注塑机注射速度的零相位滤波迭代学习控制