1.
Study on the New Technology of Hot-Dip Aluminizing of Iron and Steel and Its Surface Coating Control Model;
钢铁表面热浸镀铝新工艺及镀层厚度控制模型研究
2.
The required thickness of coating is obtained by the action of closed circuit control system above the molten zinc level (air knife).
通过气刀和镀层闭环控制系统对液态锌层厚度的调节使镀层厚度达到设定要求
3.
Mass Calculation of coating (For equal coating)/MM
锌镀层质量(两个相同锌镀层厚度)
4.
Micro-resistance test method of plating thickness of platedthrough holes for printed boards
GB/T4677.2-1984印制板金属化孔镀层厚度测试方法微电阻法
5.
Test method of plating and coating thickness by beta backscattering for printed boards
GB/T4677.8-1984印制板镀涂覆层厚度测试方法β反向散射法
6.
multilayered plating thickness X-ray spectrofluorometer
多层镀厚度x射线荧光谱仪
7.
Beta backscattering thickness meter for small area of plating (coating)
GB/T10262-1988小面积镀(涂)层β反散射厚度计
8.
Prediction Model of Coating Thickness in Hot-Dip Galvanizing
带钢连续热镀锌层厚度预测模型研究
9.
Effect of Chromium Plating Thickness on Fatigue Property of30CrMnSiA Steel
镀铬层厚度对30CrMnSiA钢疲劳性能的影响
10.
Relative quantifying technique to measure mass of fission plate in a fission chamber
裂变室镀层质量厚度的相对测量技术
11.
Based on this, coating thickness structure of tinplate was put forward and the concept of coating apparent thickness was defined.
在此基础上，建立了镀锡钢板镀层厚度结构模型，定义了镀层的表观厚度。
12.
Determination of Layers' Thickness and Bandwidth of Five-layer Transducer for PM AO Devices
PbMoO_4声光器件换能器五层镀层厚度和带宽的确定
13.
Experimental analysis on thickness control of variable thickness composite laminates during autoclave process
变厚度复合材料热压罐工艺层板厚度控制的实验研究
14.
Waveguide product plating thickness can be confirmed through surface effect depth.
通过趋肤深度,可以确定波导产品的镀层厚度。
15.
"To achieve good quality heavier coatings, srip roughness and pot chemistry must be appropriate for the combination of coating weight and line speed."
为取得良好的厚镀层,钢带粗糙度和锌锅内金属成分必须适应于镀层厚度及生产线速度。
16.
Effect of Plating Parameters on Plating Rate and Thickness as well as Surface Morphology of Electroless Tin Coating
化学镀锡工艺参数对沉积速率、镀层厚度及表面形貌的影响
17.
Surface coating control model of hot dip aluminizing
热浸铝过程中表面层厚度动态控制模型
18.
The Important Problem during the Process of Current-pouring Floor;
在现浇楼板施工中保护层厚度的控制方法