1.
Drive Control System of WRB and FRS for New High Speed Roll Mill in Xianggang
湘钢新高线精轧和减定径机组传动控制系统
2.
An Implementation of the Fault Diagnosis Expert System of the Reducing and Sizing Block on High-Speed Wire and Rod Production Line
高线生产线减定径机故障诊断专家系统的实现
3.
Application Research on Optimized Wire Rod RSM Rolling Parameters by DOE
运用试验设计优化高线减定径机组轧制参数的应用研究
4.
RSB Technology-Innovative and Reliable Special Bar Quality Production
减定径机组[RSB]技术—创新性的特钢棒材可靠生产方式
5.
A FORMULA FOR DETERMINING THE RELATION BETWEEN DIAMETER REDUCTION AND WALL REDUCTION IN TUBE-COLDDRAWING
确定冷拔钢管减径量与减壁量之间关系的公式
6.
There is a fixed relationship between the gauge length and the cross-sectional area of the test-piece at the reduced diameter.
标距长度和试样在直径减少处的横截面面积之间有固定的关系。
7.
Theoretical Calculation and FEM Simulation Analysis in Steel Tube Reducing Process;
钢管定减径过程的理论计算研究及有限元模拟分析
8.
For a fixed water/ air mass flux ratio, SMD reduces firstly and increases afterward with the increase of liquid jet diameter.
在液气质量比一定的条件下,随液体射流直径的增加,雾滴直径呈先减小后增大的变化趋势。
9.
reduce the diameter of (a wire or metal rod) by pulling it through a die.
通过冲模来减少……的直径。
10.
graduated tubing
直径分段减小的油管柱
11.
Causes responsible for bore polygonning of steel tube which appears as a defect during sizing and reducing are analyzed and common-used control methods therefor described.
简介了钢管定减径时内多边形缺陷产生的原因及其一般的控制方法。
12.
As it does so, ease up on the left hand brake to stabilize your course, but use sufficient brake to dampen the dive and prevent a closure.
因为如此，放松左边手煞车安定你的路径，但用上足够的煞车减缓这下潜和避免发生闭合。
13.
The effective diameter of the motor pulley is obtained by subtracting 5 mm from the outer diameter.
马达皮带轮的有效直径为外径减5mm 的数值。
14.
To determine the caliber of(a tube).
确定（管道的）口径
15.
The diameter of the column has now decreased to 2, 000 feet.
这时水柱的直径已减少到2000英尺。
16.
Application of the Stretch Reducing Mill in ERW Tube Production
张力减径在焊管无缝化工程中的应用
17.
Discussion on energy saving approach and energy consumption analysis in CDU
常减压装置能耗分析与节能途径探讨
18.
Allied Grenades now have a smaller damage radius (4.3 from 4.5).
手雷伤害半径减小（从4.5降低为4.3）。