1.
Simulation and Analysis on Multiple-step Stamping Process of Auto Panels;
基于数值模拟的车身覆盖件多步冲压工艺研究
2.
The prediction and control on the springback of the front inner panel of automobile at multi-steps stamping
汽车前车门内板多步冲压成形回弹预测及控制
3.
High-precision progressive stamping process with multi-way co-feeding in parallel
多向同步进料精密级进冲压工艺探讨
4.
computer numerically-controlled turret punching [CNC turrent punching]
计算机数控多头冲压
5.
Failure Behaviors of Cu/Ni Multilayer Film under Multiple Impacting and Repeating Press Load
Cu/Ni多层膜在多冲与压压载荷下的失效行为
6.
FDTD Analysis of the Step-voltages near a Grounding Electrode under Impulse Current Discharge
冲击泄流时接地体附近跨步电压的FDTD分析
7.
Numerical Simulation for Pace of Roof-broken Deep-hole Blasting for Releasing Rock-burst Danger
冲击矿压解危深孔断顶爆破步距数值模拟研究
8.
Preliminary study of a 4-stage transmission line transformer
一种四级传输线脉冲变压器的初步研究
9.
A Study on the System of Digital Pulse Compression For Multi-waveforms in Frequency Domain;
多波形频域数字脉冲压缩系统的研究
10.
Technological Process and Die Design for the Belt Sheave
板制多楔皮带轮冲压工艺与模具设计
11.
Synchronization of multi-chaotic systems via ring impulsive control
环状脉冲控制下的多个混沌系统同步(英文)
12.
Improvement of Multi-motor Synchronization Control Method for a Ship-borne Pulsed Radar
船载脉冲雷达多电机同步控制方法改进
13.
Preliminary study of multi-life detection using impulse UWB radar
冲激超宽带雷达多生命特征检测初步研究
14.
DEVELOPMENT TEST OF MULTIPLE DIE WITH HYDRAULIC COMPENSATION AND AUTO LUBRICATION
多冲模液压补偿和自动润滑模具的研制试验
15.
Superhard Multilayer Films Prepared by Pulsed Bias Arc Ion Plating;
脉冲偏压电弧离子镀沉积超硬多层薄膜
16.
Research on Influence of Sheet Carrier on Stamping Process of Multi-Position Progressive Die;
多工位级进模冲压载体形式对成形精度的影响
17.
The Numerical Simulation of the Atmospheric Pressure Glow Discharge with Multi-peaks;
多脉冲大气压辉光放电的数值模拟研究
18.
Polyphase Pulse Compression Codes Radar Signal Optimizing and Simulation;
多相编码脉冲压缩雷达信号的优化设计与仿真