1.
Study on the preparation of wear resistant surface cast by vacuum-full mould casting
真空实型铸造法制备表面耐磨铸件研究进展
2.
Visualization of Vacuum Expandable Pattern Casting Plowshare by the ProCAST Software
基于ProCAST的犁铧真空实型铸造分析
3.
The Application for Production of Special Steel Casting Produced by EPC-V Process
真空实型铸造在特殊钢件生产中的应用
4.
The characteristics and advantages of expendable pattern casting process with dry sand and vacuum are briefly introduced.
本文简述了真空实型铸造工艺的特点和优点。
5.
Research on the vacuum reproduced model casting process for composite steel-parts with wear-resistant coating
钢基耐磨复合材料的真空实型铸造工艺研究
6.
Mould filling of low-pressure expendable pattern casting process for magnesium alloys
镁合金真空低压消失模铸造充型特征
7.
A review of the history in the development of Expendable pattern casting is given in this article.
本文首先回顾了真空实型铸造的发展历史及其演变过程；
8.
Selection of Vacuum Pump and Capacity Calculation of Dust Separator in Lost Foam and V-process Casting
消失模与V法铸造用真空泵的选型和负压罐的计算
9.
The Mechanism of the Mold Collapse Defect for Iron Casting in Expendable Pattern Casting Process with Dry Sand and Vacuum
真空消失模铸造铸铁件铸型坍塌缺陷成因的研究
10.
Key Problems Analysis and Countermeasures of Vacuum Sealed Molding Casting Al-Si Alloy
铸造铝硅合金真空密封造型工艺难点分析
11.
Design method of the vacuum die-casting mould for large-scale thin shell part
大型薄壁件真空压铸模具的设计方法
12.
Pressure-expendable Pattern Casting Process for Magnesium Alloy
镁合金真空低压消失模铸造的技术特征与实践
13.
Design and Implementation of Computer Control Oriented to Vacuum Directional Solidification Cast Furnance;
真空定向结晶铸造炉数字化控制的设计与实现
14.
The first domestic fine grain cast vacuum furnace on mold agitation process has been developed successfully by Beijing Institute of Aeronautical Materials.
北京航空材料研究院研究制造了我国第一台铸型搅动工艺细晶铸造真空炉。
15.
Numerical Simulation and Experimental Research on Vacuum Casting Micro-gear
微齿轮真空铸型的数值模拟与实验研究
16.
Study on Vacuum Suction Casting for TiAl-Based Alloys
TiAl基合金金属型真空吸铸成形方法研究(英文)
17.
Study on the Influencing Factors and Filling Ability of Magnesium Alloys in the Lost Foam Casting(LFC) with Vacuum and Low Pressure
镁合金真空低压消失模铸造影响因素及充型能力的研究
18.
Microstructure of In-Situ TiC Particles Reinforced Steel Matrix Surface Composites Prepared by V-EPC
真空实型铸渗法制备自生TiC颗粒增强钢基表面复合材料的组织研究