1.
"Your network adapter settings for this connection has changed. Select an appropriate network adapter.
"您的这个连接的网卡设置以更改。请选择一个适用的网卡。
2.
Use this tab to configure the network protocol and settings.
使用此选项卡来配置网络协议和设置。
3.
Enables you to set up and configure a network adapter card and network protocol.
允许你设置和配置一个网络适配卡和网络协议。
4.
On the Connections tab, click the LAN Settings button.
在“连接”选项卡,点击“局域网设置”按钮。
5.
A Design and Implement of USB2.0 Interface of Configurable Wireless Network Card;
可配置无线网卡的USB2.0接口的设计与实现
6.
"The network adapter card was configured using default settings. Verify that the default settings are the settings that should be used and modify them if necessary.
"网卡是使用默认设置配置的。请验证该默认设置是应该使用的设置并且如果需要请修改它。
7.
NIC Express v4.0 Double Net Card Binding Realizes Redundancy Installation , Disposition and Test of Ethernet Equipment
NIC Express v4.0双网卡绑定实现以太网设备冗余的安装、配置与测试
8.
Unable to connect: You have no modem entries created, and no network card present\0
无法连接: 您未创建调制解调器连接设置,而且没有网卡。\0
9.
Unable to connect: You have no modem entries created, and no network card present
无法连接: 您未创建调制解调器连接设置,而且没有网卡。
10.
There is a problem with the protocol settings for your network card. To correct them, double-click the Network icon in Control Panel.
您的网络卡的协议设置有问题。要纠正错误,请双击“控制面板”中的“网络”图标.
11.
If it is set to promiscuous mode, network interface controller (NIC) can incept all data packet to monitor.
只要把网络接口控制器(NIC)设置为混杂模式,网卡就能接收到每一个数据包,实现监听。
12.
Design of Radio Frequency IC Card Readers Applied to IP Network;
应用于IP网络的射频IC卡读卡器设计
13.
Before using this wizard, you must first install and configure your network cards, modems, cables, and device drivers.
使用这个向导之前,您必须先安装和配置网卡、调制解调器、电缆和设备驱动程序。
14.
Find out a WL icon at the right down corner of the screen, then the WiFi LINK setting window will be open by double-click.
在屏幕的右下角任务栏处将会出现无线连接的图标,双击其后打开无线网卡的设置窗口。
15.
Bank IC Card Reissue System Based on Pre-write Technology
基于置前写技术的银行IC卡二次发卡系统设计
16.
The interrupt setting does not match those on the card. Check your hardware settings, and then try again.
中断设置与卡中的设置不匹配。请检查硬件设置,然后再试一次。
17.
The Design of a Ethernet/CANbus NIC Based on DSP;
基于DSP的以太网/CAN总线网卡设计
18.
The provisioning process encountered an error while accessing the provisioning site.
设置过程在访问设置网站时发生错误。