1.
Research on the Technology of Flaw Detection in Castings of Automobile Wheels Based on Aim Extraction and Match;
基于目标提取与匹配的汽车轮毂铸件缺陷检测技术研究
2.
Numerical Simulation of Temperature Field of the Die for Producing Wheel Hub in Die Casting Process;
汽车轮毂压铸模具温度场的数值模拟分析
3.
Numerical Simulation and Technique Optimization of the Low Pressure Die Casting Process of Aluminum Alloys Automotive Wheel;
铝合金汽车轮毂低压铸造过程的数值模拟及工艺优化
4.
The Numerical Simulation and Process Parameter Optimization in Aluminum Alloy Wheel Hub Die Casting;
汽车铝合金轮毂压铸过程数值模拟及工艺参数优化
5.
Numerical Simulation of Temperatures Field and Thermal Stresses Field of the Die for Producing Aluminum Alloy Wheel Hub in Die Casting Process;
铝合金汽车轮毂压铸模具温度场及热应力数值分析研究
6.
Casting method and Equipment Used for Resin Sand-Coated Permanent Mould Cast Wheel Hub Castings
轮毂类铸件覆砂铁型铸造工艺及设备
7.
"The wheels were made like carriage-wheels, the rods on which they were fixed, the parts forming their edges, their rods and the middle points of them, were all formed out of liquid metal."
轮的样式如同车轮。轴，辋，辐，毂都是铸的。
8.
Application of Z-Cast Software on Casting Process Optimization of Hub
Z-Cast软件在轮毂铸钢件铸造工艺改进上的应用
9.
The Electronic Differential System for In-wheel Driven Electrical Vehicle;
轮毂式电动汽车电子差速系统的研究
10.
Analysis of the Calculation and the Modes of Break-down of Automobile Hub Bearing
汽车轮毂轴承的计算及失效形式分析
11.
hob for cycle wheels (incl. coaster-braking hubs)
脚踏车车轮轮毂（包括倒轮刹车轮毂）
12.
As Cast Ferrite S.G.Iron Wheel Boss for Agricultural Trucks Produced by Town and Township Factories
乡镇小厂生产铸态铁素体球铁农用车轮毂
13.
Influence of Pressure Condition on Aluminum Alloy Hub during Filling Process of Die Casting
铝合金轮毂压铸充型阶段压力条件的影响
14.
Non-linear Pressure Condition in Filling of Aluminum Alloy Wheel in Low Pressure Die Casting
铝合金轮毂低压铸造充型非线性压力条件
15.
Analysis and Solution of Oil Leakage of Driving Axle Boss Oil Seal for Autombile
汽车驱动桥轮毂油封漏油问题的分析与解决
16.
Research and Development of Driving System for In-wheel EV
轮毂式电动汽车驱动系统的研究与开发
17.
Study and Application of Hot Extrusion Process for Boss Quill
汽车轮毂轴管复合热挤压工艺的研究与应用
18.
Research on A Method of Polishing by Digitizing for A-alloy Motor Wheel Curved Face;
铝合金汽车轮毂曲面数字化抛光方法研究