1.
"Type of frame relay connection used by the Frame Relay Profile
"帧中继配置文件使用的帧中继连接类型
2.
"Specifies whether the frame relay link comes up automatically in a Frame Relay Profile
"指定帧中继链接是否会在帧中继配置文件中自动出现
3.
Cluster configuration cannot continue because of an error during the saving of the cluster configuration. Restart the cluster configuration application and try again.
群集配置不能继续，因为保存群集配置过程中出错。请重新启动群集配置应用程序，然后再试一次。
4.
"Data Link Connection Indicator that identifies the Connection Profile to the frame relay switch
"向帧中继开关识别链接配置文件的数据链连接指示器
5.
Equipment Configuration and Optical Amplifier Module Analysis for Long-span Unrepeatered Optical-fiber Communication Systems
长跨距无中继光纤通信系统设备配置与光放大单元分析
6.
Approach for DRS Link Configuration Decision Using Physical Programming
基于物理规划的数据中继卫星链路配置决策方法
7.
Research on Relay Protection Configuration of Terminal Line Transformer Group and Transformer Neutral Point Grounding Schemes
终端线路变压器组继电保护配置及变压器中性点接地方式研究
8.
Cluster configuration cannot continue. An invalid argument was used.
群集配置不能继续。使用了无效参数。
9.
You must configure the operating system to proceed with the installation.
您必须配置操作系统才能继续安装。
10.
Type a name for this profile before continuing.
先键入该配置文件的名称，然后继续。
11.
We will now proceed through the rest of the set-top box configuration.
现在我们继续进行剩余的机顶盒配置。
12.
The Configuration Schemes for Relay Protection in 110 kV Digital Substations
110kV数字化变电站继电保护配置方案
13.
short-range pick-up television relay equipment
近距离电视中继装置
14.
plan position indicator repeater
平面位置显示器中继站
15.
Selected Policy is not available for configuration. Continue to configure by selecting a new policy.
选定策略不能用于配置。请选择新策略，继续进行配置。
16.
Answer The interface requires that the encapsulation frame-relay command be configured first.
必须要先配置封装类型才可以继续配置本地管理接口。
17.
RELAY PROTECTION FOR UHV TRANSMISSION LINES Part Two Disposition of Relay Protection
特高压输电线继电保护配置方案(二)保护配置方案
18.
Which command verifies encapsulation as well as layer 1 and layer 2 statistics on a router configured for Frame Relay?
在帧中继的配置中，哪一条命令可以用来校验数据在第一层和第二层上的封装形式?