1.
The technology of improving warp tension fluctuation of loom and reducing sparsity denseness road
改进织机经纱张力波动及降低稀密路技术
2.
The shedding and beating- up cause cycle tension variations in the warp yarns.
开口运动和打纬运动会引起在一个织造循环内的经纱张力波动。
3.
Neither objective will be achieved if the warp tension is allowed to vary.
如果经纱张力有波动,则均匀的纬纱间距和均匀的纬纱密度两者都不能得到保证。
4.
In other words, there will be fluctuations in warp tension due to the normal functioning of the system
换句话说,在系统正常工作时,经纱的张力值是波动的。
5.
Various systems have been designed to compensate for the change in warp length in shedding and so minimize the variations in warp tension.
目前有多种系统可以用来补偿开口过程中经纱长度的变化,从而降低经纱张力的波动。
6.
The force required to turn the beam is supplied by the tension in the warp yarns.
织轴的转动靠的是经纱张力的驱动。
7.
At high winding speeds, due to inertia, the rotation of the spool may lead to tension variations in the yarn.
在高速络纱时,由于惯性作用,筒子的回转会导致纱线张力的波动。
8.
These fluctuations can be minimized by reducing friction at the bearings of the levers and at their points of contact.
可以通过减少连杆轴承处和联接点处的摩擦来降低经纱张力的波动。
9.
Analysis on the Dynamic Behavior of Back Rest System and the Control of Warp Tension for an Air-jet Loom;
喷气织机后梁系统动态行为分析与经纱张力控制
10.
Development of testing system of warp tension based on optical fiber force sensor
基于光纤力传感器的经纱张力测试系统
11.
When this happens, the warp tension will increase, and the pick - spacing will be closer than normal until the roller frees itself.
在这种情况下,经纱张力会增加,纬纱间距会小于正常值。
12.
These breakage could be the result of excessive tension or, perhaps, a weak spot in the yarn.
断头的原因可能是经纱张力过大或纱线中存在弱段。
13.
Embedded System for Warp Tension Based on ARM7TDMI and uClinux Architecture;
基于ARM和uClinux的经纱张力嵌入式系统设计
14.
The Study of Warp Tension Control System Based on Nios;
基于Nios软核的经纱张力控制系统的研究
15.
Application of Magnetostrictive Pick-up to Constant Tension Control of Warp;
织机恒经纱张力控制中磁致伸缩传感器的应用
16.
Fuzzy Parameter Self-Tuning PID Control for Warp Thread Tension Control
经纱张力的模糊参数自整定PID控制研究
17.
Non-contact dynamic measurement of yarn tension in winding process
非接触式纱线卷绕张力动态检测方法的研究
18.
To help maintain uniform tension in the filling yarns
有助于纬纱张力的均匀。