1.
Override settings from user profile and Remote Desktop Connection or Terminal Services client
替代用户配置文件和远程桌面连接或终端服务客户端的设置
2.
Media Center has been shut down because it was running in a mode that is not supported over a remote desktop connection. Please restart Media Center to correct.
媒体中心已关闭，因为它以远程桌面连接不支持的模式运行。请重新启动媒体中心进行纠正。
3.
This server is configured in the default Remote Desktop mode for remote administration, which allows a maximum of two simultaneous remote connections.
这台服务器的配置是远程管理的默认远程桌面模式，这允许最多两个用户同时进行远程连接。
4.
Use the "Remote Desktop Users" group to grant user rights to logon remotely. The Adminstrators group has full access to all connections.
使用“远程桌面用户”组来授予用户远程登录的权利。“管理员”组对所有连接都有完全控制权。
5.
Connect to a computer's desktop from a remote location, and run applications as if you were sitting at its console.
从远程位置连接到计算机的桌面并运行应用程序，如同您坐在其控制台前面。
6.
Turning Remote Desktop listener on or off remotely.
远程打开或关闭远程桌面侦听器。
7.
A hinged or removable section for a table top.
活动桌面桌子上部有铰链连接或可移动的部分
8.
Remote Desktop does not exist or not properly installed on local machine
本地机器上没有远程桌面或没有正确安装远程桌面
9.
The remote system refused the network connection.
远程系统拒绝网络连接。
10.
Establishing connection to desktop computer. Please wait...
正在与桌面计算机建立连接，请稍候...
11.
When enabled, connect to the desktop computer using:
启用后，连接至桌面计算机可使用:
12.
Changes device identification desktop connectivity settings.\0
更改设备标识符和桌面连接设置。\0
13.
Changes device identification desktop connectivity settings.
修改设备标识与桌面机连接设置。
14.
Enable Remote Desktop Sharing on this computer
请启用这台计算机上的“远程桌面共享”
15.
Do not install Terminal Server for Remote Desktop (Remote Administration). Remote Desktop is enabled by default.
不要为远程桌面(远程管理)安装终端服务器。根据默认值，远程桌面处于启用状态。
16.
Direct Connection~~Connects through infrared or a serial cable to a desktop computer.
直接连接~~通过红外线或串行电缆连接到桌面计算机上。
17.
To disable remote connections to this computer, clear the check box below.
要停用这台计算机的远程连接，请清除下面的复选框。
18.
Unable to establish an infrared connection while mobile device is connected to the desktop.
当移动设备连接到桌面计算机时，无法创建红外线连接。