1.
Standard for protective spacing of radio interference from over-head electric lines, sub-stations to television transposer station and retransmitting station
架空电力线路、变电所对电视差转台、转播台无线电干扰防护间距标准
2.
Analysis on coordinate conversion error of airborne measuring device
机载测量平台中的坐标转换误差分析
3.
Research on Uncertainty of Rotating Angle Error of Servo Turntable
伺服转台回转角度误差的不确定度研究
4.
There exist manufacture and install errors in the actual six degrees of freedom motion platform, these errors will affect the platform's position and pose precision.
实际的六自由度转台存在着制造、装等误差,这些误差都会影响转台的位姿精度。
5.
Study on motor control strategy of the mutual-feedtest bed based on slip frequency
基于转差频率的互馈试验台电机控制策略研究
6.
Analysis of error compensation on NC gear shaper workbench
数控插齿机工作台回转误差补偿之分析
7.
Error Analysis and Simulation of Azimuth Rotating GINS
方位旋转式平台惯导系统的误差分析与仿真
8.
A Test Bed for the Deviation of Steering Wheel Angle and the Center Plane of Front-Rear Wheels of Motorcycles(1)
摩托车转向轮转角及前后轮中心平面偏差测试台(1)
9.
Typical machining tolerances on this table, which was designated as Model A, were in the range of 0.001 to 0.0001 inch.
这种后来定名为A型的转台，其典型零件加工公差在0．001到0．0001时之间。
10.
Extracting Dynamic Error of Accelerometer Tested on Three-axis Turntable by Quaternion
用四元数法提取加速度计三轴转台测试中的动态误差量
11.
The Experimental Calibration of Angular Acceleration Parameters of Strapdown Gyroscope on Three-Axis Turntable
捷联陀螺角加速度误差系数在三轴转台上的实验标定
12.
Analyse of Axis-Errors and Compensating in Terminal of Intersatellite Optical Communication;
卫星光通信终端二维转台轴系误差分析及补偿方法研究
13.
Influence of turntable angular position reference errors on laser SINS calibration
转台角位置基准误差对激光捷联惯导标定的影响分析
14.
Research on Thermal Error Modeling,Measurement and Compensation for the Two Turntable 5-Axis NC Machine Tools
双转台五轴数控机床热误差建模、检测及补偿实验研究
15.
a mechanism for revolving the turntable
旋转台 [转盘] 的旋转装置
16.
This is a heavy duty turret lathe.
这是一台重型转台车床。
17.
static torque calibuation stand
转矩[扭矩] 静校台
18.
for example, a device that converts between bit serial and bit parallel and resolves differences in transmission speeds.
例如,一台在串行位和并行位之间作转换且解决传输速度差别的设备。