1.
The main interference source is spark plug, high-voltage ignition coil cap and the high-voltage coil.
主要干扰源是火花塞、压点火线帽和高压点火线。
2.
High tension ignition wires for road vehicle--Part 2 Copper conductor high tension ignition wires
GB/T14820.2-1993公路车辆用高压点火电线第2部分铜芯高压点火电线
3.
Device of Simulating "Violent Burning" in Gasoline Engine;
模拟汽油机“猛烈燃烧”高压点火器的制作
4.
High tension ignition wires for road vehicle--Part 1 Genera
GB/T14820.1-1993公路车辆用高压点火电线第1部分一般规定
5.
Gas burners are ignited by a high-voltage spark in a pilot gas stream or by an electrically heated wire.
煤气烧嘴可在引火煤气流中用高压电火花点火，亦可用电热丝点火。
6.
Ignition secondary circuits produce high voltagws.
次级点火线圈高电压，操作注意。
7.
Fire safety analysis on the high burning point insulating oil of transformers
高燃点绝缘油变压器的防火安全对策
8.
compression ignition
(发动机)压缩点火
9.
The ignition system provides high-voltage electric sparks that set fire to the air-fuel mixture in the engine combustion chambers.
点火系产生高压电火花，点燃发动机燃烧室内的可燃混合汽。
10.
INSPECT AND REPAIR IGNITION WIRINHIGH VOLTAGE CABLES CAN CAUSE INTERFERENCE.
检查和修理点火导线。高压电缆能够引起干扰。＊
11.
Investigation of High Compression Ratio and Ignition Timing Control for Gas Engine;
燃气发动机高压缩比和点火正时控制的研究
12.
Discussion on Safety of Fire Prevention of High Ignition Point Vegetable Insulation Oil Transformer
高燃点植物绝缘油变压器防火安全性探讨
13.
compression-ignition internal combustion engine ,piston
压缩点火活塞内燃机
14.
piezoelectric burner igniter
压电燃烧器点火装置
15.
"Any check of the ignition system should start at the battery and cables and should take in the coil, distributor, low-and high-tension wiring, and spark plugs."
点火系的任何一项检查都应该从蓄电池和线路开始,并检查线圈、分电器、高低压电路和火花塞。
16.
The ignition system provides high-voltage electric parks that ignite, or set fire to, the charges of air-fuel mixture in the engine combustion chambers.
点火装置产生高压电火花，从而使发动机燃烧室中的可燃混合气起燃。
17.
Electromagnetic wave radiation produced due to the high voltage spark ignition will interfere the radio receiving system nearby.
摩托车汽油机由高压电火花点火,产生电磁波辐射,对在其附近的无线电接收设备造成干扰。
18.
testing method for annealing point and strain point of glass by beam bending
玻璃退火点和软化点测定方法-压梁法