1.
The compressed volume file for drive %1 cannot be found. Check drive %2 for errors using ScanDisk.
找不到驱动器 %1 的压缩卷文件，请用“磁盘扫描程序”扫描驱动器 %2。
2.
Research and Implementation of Time-Space Mix-Modulation and Scan-Drive Model for TFT-LCD
TFT-LCD时空混合调制扫描驱动模型的研究与实现
3.
Show scanner driver dialog before scanning
在扫描前显示扫描仪驱动程序对话框
4.
(This scanner will always display the scanner driver dialog.)
(扫描仪将始终显示扫描仪驱动程序对话框。)
5.
Research on Extensible Policy-Driven Network Vulnerability Scanning;
策略驱动的可扩展网络漏洞扫描研究
6.
Drive Circuit Research for Laser Scanner Based on FPGA;
基于FPGA激光扫描器驱动电路研究
7.
"Unable to access scanner device. Make sure scanner drivers are installed correctly, and no other scanning applications are running.
"无法访问扫描仪设备。请确定扫描仪驱动器安装正确，并且没有运行其它扫描应用程序。
8.
ScanDisk did not find any errors on this drive.
“磁盘扫描程序”在此驱动器没有找到任何错误。
9.
Design and Realization of the Driver Program of Multi-CCD Scanner;
多CCD大幅面扫描仪的驱动程序设计与实现
10.
The Design and Implementation of the Base Layer Driven Software for a Large Scale CIS Scanner;
大幅面CIS扫描仪底层驱动软件的设计和实现
11.
The Design of Driving Power Source and the Study on Scanning Algorithm Applied to LED Panel
LED显示屏的驱动电源设计和扫描算法研究
12.
Quit ScanDisk, free some space on this drive, and then restart ScanDisk.
请退出“磁盘扫描程序”，释放部分驱动器空间，然后重新启动“磁盘扫描程序”。
13.
ScanDisk found errors on this drive and fixed them all.
“磁盘扫描程序”在此驱动器上找到错误并全部修复。
14.
ScanDisk found errors on this drive but did not fix all of them.
“磁盘扫描程序”在此驱动器找到错误，但是并未全部修复。
15.
ScanDisk found errors on this drive but did not fix any of them.
“磁盘扫描程序”在此驱动器找到错误，但是并未修复任何错误。
16.
ScanDisk was unable to completely correct this error because this drive does not have enough space.
因为这个驱动器空间不够，所以“磁盘扫描程序”无法彻底更正错误。
17.
then run ScanDisk again and choose to conduct a standard test on the drive.
然后再运行“磁盘扫描程序”，在驱动器运行标准测试。
18.
Design and Realization of Multi-USBScanner Device Driver in VxWorks System;
基于VxWorks嵌入式系统的多路USB扫描仪设备驱动的设计与实现