1.
Research on the Loading Localization Based on the Wireless Sensor Network;
基于无线传感网络的载荷定位的研究
2.
The Effects of the Position of the Screw in the Dynamic Compression Plates on the Stability of Plate and Screw Structure;
螺钉位置对钢板螺钉内固定结构载荷的影响
3.
Describes a method to measure the dynamic rock complete load-displacement curve.
介绍了一种测定岩石动态荷载-位移全过程曲线的实验技术。
4.
The resultant effect at any chosen point is the sum of the effect of the various loads.
在任意指定的部位上，总的作用力是各载荷作用的总和。
5.
Study on Mechanical Behaviour of Rock Mass on High-Steep Slope Under Load and Determination of Bridge Foundation Position
荷载作用下高陡边坡岩体力学行为及桥基位置确定方法研究
6.
Study on Three-Dimensional Mechanical Behaviour of Rock Mass on High-Steep Slope under Bridge Load and Determination of Bridge Foundation Position;
桥基荷载作用下三维高边坡岩体力学行为及桥基位置确定的研究
7.
Fatigue Analysis of the Spud System of the Cutter Suction Dredger by Wave Load
挖泥船定位桩系统在波浪载荷作用下的疲劳强度分析
8.
Analysis of Estimating Ultimate Loading and Static Test of Screw Pile Under Inclined Loading
承压螺旋桩斜向荷载试验与极限荷载判定分析
9.
DETERMINING OF THE FOURK-SIDES NON-FIXED RECTANGLE PLATE'S EQUIVALENT UNIFORM DISTRUBUTED LOAD IN THE CONCENTRATED LOADS
集中荷载作用下双向板等效荷载的确定
10.
Rated operating load for loaders
GB/T10175-1988装载机额定工作载荷
11.
The Design Disk-model Constant Load Material Tester and Research of Constant Load Test;
圆盘式定载荷全息材料试验机及定载荷试验研究
12.
location of gasket load reaction
垫片载荷作用位置处的直径
13.
Retaining walls in the stratification of the wall under load displacement
挡土墙在分层荷载作用下的墙身位移
14.
For a unit of projected area, the loading on a telephone pole or a smokestack will be less than on an I-beam.
对一个单位面积来说，电线杆或烟囱上的荷载要比工字架上的荷载
15.
Deep groove ball bearings mainly take radial load as well as take moderate axial load.
深沟球轴承主要承受径向载荷，也可承受一定量的轴向载荷。
16.
This paper presents a method determining analytical and process bandwidth in load identification.
本文研究在载荷识别中确定载荷的分析处理频带宽度的方法。
17.
Loading Conditions. The selection of loading conditions follows the determination of the type and magnitude of the loads that act on the structure.
荷载条件。确定了作用在结构上的荷载类型大小之后，接着要选择荷载条件。
18.
Study Bearing Capacity of Revolving Digging Cast-in-Place Bored Pile Through Load Transfer Method;
荷载传递法确定旋挖钻孔灌注桩承载力的研究