1.
The most important of the results is the finding of significant axial variations of the combustion parameters.
最重要的结果是燃烧参数的轴向变化显著。
2.
Analysis on properties of vertical stress-stain of six solidified saline soils inshore
六种固化滨海盐渍土的轴向应力应变特征
3.
Study on axial length changing and its controlling during heat treatment of 440C steel tube
440C钢管热处理轴向尺寸变化规律与工艺控制
4.
coaxial variable direction coupler
同轴可变定向耦合器
5.
The effect of radial load to radial stiffness can be neglected.
径向载荷的变化对轴承径向刚度的影响可以忽略.
6.
Specification: direction of rotation of output shaft varies with that of input shaft.
说明：当输入轴旋转方向改变，输出轴相应改变。
7.
the shape, run and change trend of shaft center trajectory are consistent to the test result too.
轴心轨迹的形态、走向及变化趋势与实验结果相吻合。
8.
The Significance and the Expression Changes of Slit-2 during the Spinal Cord Injury of Rats;
大鼠脊髓损伤后轴突导向因子slit-2的表达变化及意义
9.
Dynamic display of the rotation of display elements about an axis the orientation of which is continuously changing in space.
显示元素相对于一个轴旋转的动态显示过程，此轴在空间的方向是连续不断地变化的。
10.
Analysis of Axial Velocity With Perspective Affine Transformation
轴向变形系数的透视仿射变换法分析
11.
Axial load-deformation curve and preload on angular con act ball bearings
角接触球轴承的轴向载荷—变形曲线和预紧
12.
Introducing The Coefficient of Asle Direction Changed Shape andthe Size of Angle Between Axle and Asle From the Formation of Posi-tive Equal AnoprojEction
从正等轴测图形成过程分析轴向变形系数和轴间角的大小
13.
This accommodates any effective change of length of the propeller shaft as the rear axles move toward or away from the car frame.
当后桥在车架上向前或向上运动时,这种结构足以调整传动轴长度的任何变化。
14.
By transverse exposure, periodical modulation of refractive index is formed along the axis of optical fiber.
制备原理是对光纤横向曝光，使光纤的折射率指数在轴向发生周期性变化。
15.
There must be one or more universal joints to permit variations in the angle of drive. There must also be a slip joint that permits the effective length of the propeller shaft to change.
一个或几个万向节来适应传动角度的变化;一套伸缩花键,能够改变传动轴的现有长度。
16.
Axial forces in the three working rollers reaches maximum at startup.
三个工作轮的轴向力随着变矩器的工况变化，在起动工况时达到最大值。
17.
Neglect the axial deformations and consider only the lumped masses.
略去轴向变形不计，仅考虑集中质量。
18.
CALCULATION OF SHEARING STRESS FOR AXIAL DRAWING OF TRANSFORM SECTION BAR
变截面直杆轴向拉伸时的剪应力计算