1.
Study on Charge Standard Calculation Method for Toll-by-weight Based on Equivalent Axle Theory and Equivalent Coefficient Theory;
基于当量轴次和当量系数理论的计重收费计算方法研究
2.
Equivalent factors of multi-axle loads for asphalt surfacing on steel bridge decks
钢桥面铺装多联轴荷载的当量轴数研究
3.
inversion monad
一次倒反轴, 一次倒转轴
4.
Research on Motion Model of Constant h_(eq)Non_circular Crankshaft Grinding
曲轴非圆的恒当量磨削厚度磨削运动模型研究
5.
DOsage and Administration） A day spray3-5 times, massage every time properly for5 minutes.
【用法用量】日喷涂3—5次，每次适当按摩5分钟。
6.
⑤ Pod yield was similar with seed, oil, protein yield and output value precedence.
⑤荚果产量与籽仁、油、蛋白质产量和产值位次相当
7.
Spindle feeds and speeds are controlled by selector levers which engage the proper gears in the drill head.
主轴的进能量和转速是通过选速杆使主轴箱中的适当齿轮相啮合而控制的。
8.
When the exterior normal is opposite to the coordinate axis, then the positive stress components are in the opposite directions of the coordinates.
当外向法线和坐标轴相反时，正的胁强分量就是沿着和坐标轴相反的方向的。
9.
The wheelbase must have an adequate length too.
轴距也应该有适当的长度，因为该参量可以影响底盘强度。
10.
Equivalent Linearization Method for Limit Cycle Flutter Analysis of Plate-Type Structure in Axial Flow
轴向流中板状结构极限环颤振分析的当量线性化法
11.
Total Weight (Less Bearing)
总重量(较少轴承)
12.
This means that the crankshaft will make two revolutions for every revolution of the camshaft.
这意味着凸轮轴每旋转一次曲轴将旋转两次。
13.
Every time he bats an eyelid, every time his heart takes a pumping stroke, cells must provide energy.
每当他眨一眨眼睛，每当他的心脏搏动一次，细胞都必须提供能量。
14.
Angular momentum is an axial vector quantity.
角动量是一种轴矢量。
15.
In rotating, the shaft splashes oil up into the bearings.
当轴旋转的时候就把油溅入轴承。
16.
Rotate the pinion yoke three or four times.
旋转小齿轮轴轭三次或四次。
17.
Measuring diameter of fore and aft stern tube bearing and bushes.
艉轴管前、轴承与衬套直径测量。
18.
Crankshaft Grinding Process on the Quality of Study on the Impact of the Crankshaft
曲轴磨削工艺对曲轴质量影响的研究