1.
REASONS FOR THE LEAKAGE OF HP EQUIPMENT SEALING SURFACE AND PROTECTING MEASURES
高压设备密封面泄漏原因分析及防护措施
2.
INSPECTION FOR REAR SEAL AREA LEAKS
后密封区的泄漏检查
3.
STUDY ON OUTWARDLY PUMPING CIRCULAR ARC GROOVED LIQUID FACE SEAL WITH ZERO-LEAKAGE
泵出式圆弧槽无泄漏液体端面密封研究
4.
The primary and mating seal faces are lapped to a maximum of 3-helium light bands flatness to provide effective sealing and leakage protection.
主密封面和配套密封面叠加成最多3层的轻型带状平面,提高密封和防泄漏效果。
5.
If the leakage occurs at the rear oil seal area, refer to the section, Inspection for Rear Seal Area Leak.
如果泄漏发生在后机油密封区，参看“后机油密封区泄漏的检查”一节。
6.
Numerical Simulation on Pressure Distribution and Face Leakage of Rotary Pressure Exchanger
旋转式压力能交换器密封端面液膜压力和泄漏量的数值模拟
7.
The primary function of sealing gasket is to prevent gas from leakage.
密封垫圈的主要作用是防止气体泄漏。
8.
Sealed radioactive sources--Leakage test methods
GB15849-1995密封放射源的泄漏检验方法
9.
Seat ring is seal welded to eliminate leak path.
阀座环通过密封焊接，消除泄漏通道。
10.
Radiation protection - Sealed radioactive sources Leakage test methods???
辐射防护－－密封放射源泄漏检验方法
11.
This check does not simulate a seal leakage.
这个测试并不等同于密封泄漏。
12.
Analysis of Dynamic Performance and Leakage for Finger Seal
指尖密封动态性能分析与泄漏量计算
13.
Analysis and Improvement of Leaking Cause for GA5201 Mechanical Seal
GA5201机械密封泄漏原因分析及改造
14.
This paper analyzes the leaking and sealing mechanisms of toilet commponents' water drain valve in detail and gives the solution of the leaking problem of water drain valve.
详细分析了低水箱配件排水阀密封泄漏的机理,提出了排水阀密封泄漏问题的解决方法。
15.
What have you to say as to the revelations in this letter?
你对这封信里泄漏的秘密又怎么解释呢？
16.
4 Ducts shall be suitably welded or sealed for leakage.
管路有合适的焊接和密封，来保证不泄漏。
17.
Analysis of Rationality to the Seal Device Structure of the Rotate Axis Without Moving Leaking Point
旋转轴无动泄漏点的密封装置结构合理性分析
18.
Roughness and Rod Speed for Influence of Hydraulic Reciprocating Rod Seals Leakage
粗糙度和杆速对液压往复杆式密封泄漏的影响