1.
Brix Distribution in Stem and Relations With Other Characters of Hybrid of Sorghum×Sudan Grass.
高粱—苏丹草杂交种茎秆糖锤度的分布及与其它性状的关系
2.
The mean Brix of main stem was 10.31% in hybrid which were produced with improved sudan grass.
利用改良苏丹草配制的杂交种，其主茎平均糖锤度为10．31％。
3.
The mean Brix is 5.60% and the highest Brix is 8.27% in main stem of hybrid which was produced with present existing sudan grass.
利用现有苏丹草配制的杂交种，其主茎平均糖锤度为5．60％，最高为8．27％；
4.
the earlier harvest can decrease the sugar content about 2.0Brix.
其次是提前收获,可降低含糖约2.0锤度。
5.
RESEARCH OF THE RELATIONSHIP BETWEEN BRIX RATIO OF THE UPPER AND THE LOWER PARTS OF SUGARCANE PLANTS IN ZHANJIANG AND SUGAR CONTENT IN THEM
湛江市甘蔗上下节锤度比与糖分关系研究
6.
An Analysis on the Reliability of Sugar Content Determined by Brix Spindle
用锤度计测定甜菜含糖率的可靠性分析
7.
Studies on Brix Degree, Tota Sugar Content and Their Relationship in the Juice of Sweet Sorghum Stem
甜高粱茎秆汁液锤度与总糖含量间相关性的研究
8.
while there is no significant difference among the relationships between field brix sugar content in different varieties of sugarcane.
而不同甘蔗品种间田间锤度———糖分关系可用同一模型来描述。
9.
Mathematic models for quantitative analysis of Brix and reducing sugars in sugarcane juice with Fourier transform near infrared spectroscopy
甘蔗蔗汁锤度和还原糖分傅立叶变换近红外定量分析数学模型
10.
The relationship between the Brix and the total soluble sugar content of sweet sorghum stalk juice was determined through one-dimensional linear regression.
本文应用一元线性回归分析法得出了甜高粱茎秆汁液锤度和可溶性总糖含量之间的关系。
11.
Brinell impact hardness tester
锤击式布氏硬度试验机
12.
double impression method
锤击布氏硬度测定法
13.
The brix degrees of the individual internodes of the 6th,7th,13th,3rd and 2nd internodes had high directly positive effects on the birx of the whole stem.
上数第6,13,7,3,2茎节的锤度对茎秆混合锤度有较大的正直接效应;
14.
(The pendulum is usually measured from the top point to the middle of the bob.
我们称底部的重物叫摆锤（摆的长度一般从顶点到摆锤中间来计算）。
15.
(of water depth) measured by a line and plumb.
（关于水的深度）由绳子或测锤测量的。
16.
Unplumbed ocean depths.
未用铅锤测量的海洋深度
17.
Effects of Different Sowing Dates on the Yield and Brix of Sweet Sorghum
不同播期对甜高粱产量和锤度的影响
18.
Production has slowed because the steam hammer is broken.
车间里的蒸汽锤坏了, 导致工程进度放慢。