1.
The Melt Rheological Behavior of m-LLDPE at High Speed Extrusion
m-LLDPE高速挤出流变性能研究
2.
On-Line Measurement and Control of the Flow in Precise Extrusion of Polymers
聚合物精密挤出过程中挤出流量的在线测量及控制方法
3.
FEM Analysis in the Effect of Die Compression Section on Plastic Extrusion Flow
口模压缩段对塑料挤出流动影响的有限元分析
4.
The Melt Flow Instability of LLDPE, LDPE and Their Blends at High Speed Extrusion;
LLDPE、LDPE及其共混物高速挤出流动不稳定性的研究
5.
Extrusion Flow Instability of Polythene and Its Blends;
聚乙烯及其共混物挤出流动不稳定性的研究
6.
Numerical Analysis and Experimental Study of Polymer Micro Extrusion Flow;
聚合物微挤出流动过程数值分析与试验研究
7.
When you close your hand and press, some of the water gets out.
当你把手握紧挤压时，会流出一些水。
8.
Study on Three-Dimensional Flow of Coat-Hanger Die for Sheet Extrusion
板材挤出衣架式机头三维流场的研究
9.
THE FLOW ANALYSIS OF POLYMER MELT IN CO-EXTRUSION DIE
共挤出机头中的聚合物熔体流动分析
10.
The Stability of Two-Phase Flow Interface in Gas-Assisted Extrusion
气辅挤出成型中两相流界面的稳定性
11.
Parametric Design and Flow Field Analysis of Pipe Die for Extrusion;
管材挤出机头流道参数化设计及流场分析
12.
Analysis of fluid field in wide sheet extruder die with both end feeding
两端进料式宽幅片材挤出机头流道流场分析
13.
Extruder and hual off adopt AC frequency conversion technology.
挤出机、引机等采用交流变频控制技术，调整方便。
14.
Simulation of Flow Instability of Polymer in Extrusion Die
在挤出机口模中聚合物不稳定流动的模拟
15.
WALL SLIP PHENOMENON OF RUBBER COMPOUNDS IN EXTRUSION DIE FLOW
橡胶在挤出口型流动中的壁面滑移现象
16.
Extrusion Process Flow and Die Structure for Plastic Net
塑料网的挤出成型工艺流程及模头结构简介
17.
Computer-aided design of sprue in extrusion die head for plastic profiled bar inner rib
塑料异型材挤出模头内筋流道的辅助设计
18.
Computer Simulation System for 3D Flow of Profile Extrusion Die
异型材口模挤出三维流动计算机模拟系统