1.
Study on the Structural Properties and Process of Friction Stir Welding of MB3 Alloys;
MB3镁合金搅拌摩擦连接工艺及组织性能研究
2.
New Technology of Solidoid Jointing Stir Friction Welding
固相连接新技术——搅拌摩擦焊技术
3.
Treatment method of the high strength bolt friction type connection interface
高强度螺栓摩擦型连接接触面的处理方法
4.
EXPERIMENTAL STUDY ON ANTI-SLIDING COEFFICIENT OF FRICTION TYPE HIGH-STRENGTH BOLT CONNECTORS
摩擦型高强度螺栓连接件抗滑移系数试验研究
5.
Welding process analysis of bimetal valve friction wielding
双金属气门连续驱动摩擦焊焊接工艺分析
6.
touch or rub constantly.
经常地接触或发生摩擦。
7.
Fibrillation: In paper making, the process of roughening the outside of the fibre to increase bonding capabilities.
纤丝化:在造纸过程中，把纤维的外表摩擦起毛，以增加连接能力。
8.
Function of Ball Bearing is to connect two machine members that move relative to one another so that the frictional resistance to motion is minimal.
球轴承的作用是连接两个作相对运动的机件,并使摩擦力降低到最
9.
The clutch is a friction-type uncoupling device. It is linked to a clutch pedal in the driver's compartment.
离合器是一种摩擦式分离装置,与驾驶室中离合器踏板相连接。
10.
Study on the Process and Mechanism of the Zr-Based Bulk Metallic Glasses during Friction Stir Welding
锆基块体非晶态合金的搅拌摩擦焊连接工艺及机理研究
11.
The interaction of sliding surfaces is modeled with a Coulomb friction law.
接触面间的摩擦约束采用库仑摩擦模型。
12.
metal to-metal contact
干摩擦金属与金属直接接触
13.
These fluctuations can be minimized by reducing friction at the bearings of the levers and at their points of contact.
可以通过减少连杆轴承处和联接点处的摩擦来降低经纱张力的波动。
14.
the disturbances caused by joint gap, friction,or internal impact within limited distance, gravity and aerodynamic drag are discussed.
还对连接间隙、摩擦、限位内碰撞、预应力、重力场及空气阻力的干扰进行分析；
15.
For sliding contact, the coefficient of kinetic friction Uk is defined as the ratio of the frictional force to the normal force.
滑动接触时，动摩擦系数Uk的定义是摩擦力与法向力的比率。
16.
The friction is modeled with a modified coulomb friction model.
模具与板料的接触摩擦采用一个修正的库仑摩擦模型。
17.
Effect of Non-component Adhesive on the Friction and Wear Performances of Paper-based Friction Material
非组分黏接剂对纸基摩擦材料摩擦磨损性能的影响
18.
Do you mean the shaft will run against the bush?
你的意思是轴会与轴承套直接摩擦吗？