1.
Measuring method for size and deviation of vitrified clay pipe
GB/T2837-1998陶管尺寸及偏差测量方法
2.
Research on Measuring Technology of Ultraprecision Gear Total Cumulative Pitch Error;
超精密齿轮齿距累积总偏差测量技术的研究
3.
Measuring and Analysis of Pitch Deviation and Tooth Form Deviation of Bevel Gear
锥齿轮齿距及齿形偏差测量与分析方法
4.
Research on Measuring Uncertainty Parameter of Tooth Profile Slope Deviation
齿廓倾斜偏差测量不确定度参数的确定
5.
Parameterize Tooth Profile Slope Deviation Measuring Uncertainty in Gear Measuring Center Standard
齿轮测量中心标准中齿廓倾斜偏差测量不确定度参数的确定
6.
standard deviation of the arithmetic mean of a series of measurements
测量列算术平均值的标准（偏）差
7.
Combined Measuring Method and Simulation of Deviation on Target by CCD and MEMS
CCD与MEMS组合测量弹丸落点偏差的方法
8.
The estimated amount or percentage by which an observed or calculated value may differ from the true value.
偏差，误差测算价值相差于实际价值的大概数量或百分点
9.
Analysis on Water Content Deviation of Expansive Soil Measured by Moisture Measurement System Based on TDR
基于TDR技术的水分测量系统量测膨胀土含水量偏差分析
10.
Impact on Strain Measurement by Fiber Bragg Grating of Error of Installation
安装偏差对光纤布喇格光栅应变测量的影响
11.
Mathematic Model of Axis Deviation Influence on Surveying Angle and Its Correction;
轴系偏差对测量角影响的数学模型及改正方法
12.
Research of On-Line Measuring Principle and Technology of Large Gears Pitch Error;
大齿轮齿距偏差在机测量原理与技术的研究
13.
Theoretical and Experimental Study on the Heterodyne Interferometric Ellipsometry;
外差干涉椭圆偏振测量的理论与实验研究
14.
The Research of Extracting the Information of Weld Deviation and the Measurement of Tracking Precision
焊缝偏差信息提取与跟踪精度测量方法研究
15.
Error Analysis and Optimization of Center-Deflection-Measure Data
中心偏测量数据的误差分析及数据优化措施
16.
Influence of parasitic ghost reflection on measurement in a heterodyne interferometric ellipsometer
寄生虚反射对外差干涉椭偏测量的影响
17.
Influence of Metal-Coated Mirrors on Measurement Accuracy in Heterodyne Interferometric Ellipsometry
金属反射镜对外差干涉椭偏测量精度的影响
18.
The polarization grade of three lamps for the laboratory and the polarization error of two illuminance meters are measured.
测量了实验室用的三支灯的偏振度及两台照度计的偏振误差。