1.
A SINS Nonlinear Error Model Reflecting Better Characteristics of SINS Errors
基于欧拉平台误差角的SINS非线性误差模型研究
2.
The Reflected Beam's Phase Aberration Induced by the Fabrication Errors of Corner Cube Retroreflector
角锥棱镜的误差引起的反射光束相位误差分析
3.
This article discussed the method to reduce the error of the calculation from three aspects: error by not in-phase, difference in sample frequency and ideal sample frequency, and finite register length effects.
本文从减小同步误差、小频差序数和减小舍入误差等三个方面入手,减小功率因数角的计算误差。
4.
Analysis of Inspection and Measuring Method for 120° Distributing Angle Errors of Crankshaft Crankpins
曲轴曲拐120°角度误差检测方法分析
5.
The Optical Lever Enlarging Method Produced Error Because of the Angle;
光杠杆放大法测量中α角产生的误差
6.
Simulation Analysis of Phase-compare Angle Measurement Error Caused by Multipath over Sea Surface
海面多路径下比相测角误差仿真分析
7.
Covariance Analysis of Missile-to-Target LOS Pointing Angle Error for SAM
地空导弹弹目视线指向预定角误差协方差分析
8.
A Novel Polarization Angle Sensor and Error Compensation Algorithm for Navigation
新型仿生偏振测角传感器及角度误差补偿算法
9.
Effect of Helix Angle Errors on Transmission Error of Double Circle Arc Helical Gears
双圆弧齿轮的螺旋角误差对其传动误差的影响分析
10.
Through polar coordinate method error calculus demonstrated that the setting-out point error is mainly caused by angle measurement error.
通过对极坐标法误差的计算论证了放样点误差主要是由测角误差引起。
11.
alignment error
安装误差;调准误差;定线误差;校正误差;校直误差
12.
Secondly there is error between thethread roll angles of thread rolling die and drill rod.
滚丝轮螺纹和钻杆螺纹的螺旋角有误差。
13.
The error in azimuth must be controlled by astronomical observations for azimuth(and longit ude).
方位误差必须观测天文方位角（及经度）来控制。
14.
The error pickoff is an angle-to-voltage transducer.
误差检测器是把角度转换为电压的传感器。
15.
Simplified Algorithm for Trigonometry Meshes with Attributes Based on Quadric Error Metric
基于二次误差测度的带属性三角网格简化算法
16.
Posture error analysis on the Cartesian coordinates serial-parallel robot with redundant drive
冗余驱动直角坐标串并联机器人位姿误差分析
17.
Verification O Class Plane Planeness Error Research With small Angle Instrument
小角度仪器检定0级平板平面度的误差研究
18.
The adjustment of rotation angle error of power box twin export axles of twin screw extruder
双螺杆挤压机动力箱双输出轴转角误差调整