1.
Cause of Excessive Temperature of Cover Bolt of Russia-made TBB-500-2EY3 Generator
俄制TBB-500-2EY3型发电机端盖螺栓温度高原因分析
2.
Cold punching processing design of the FH_2-40 motor's rear cover
FH_2-40型电动机后端盖冷冲压工艺设计
3.
The CAPP of motor end cover components
电动机端盖零件的计算机辅助工艺设计
4.
useful output at termina
发电机出线端净出力
5.
The Reliability Analysis on the End Covers of In-wheel-motor Under Locked Brake Condition
制动抱死工况下轮毂电机端盖的可靠性分析
6.
a detachable plate that covers the closed end of a cylinder chamber in a reciprocating engine or pump.
覆盖在往复式发电机引擎的汽缸内腔的封闭一端的可分离的盘状物体。
7.
Turn the locking bolt so that it is fixed on the bake cover or the flange plate.
安装后必须将锁紧螺母锁紧在电机后端盖或法兰盘上。
8.
Turn the hollow bolt so that it is fixed on the bake cover or the flange plate.
安装后必须旋出空心螺栓锁紧在电机后端盖或法兰盘上。
9.
Analysis and Solution of Endshield-type Oil Leakage in High-Speed Motor
高速端盖式滑动电机轴承漏油问题的分析与解决措施
10.
Remove upper generator mounting bolt.
拆下上端发电机安置螺栓。
11.
Model of Quasi-Stationary Eddy Current Field in the End Region of Turbogenerators
汽轮发电机端部似稳涡流场数学模型
12.
The Analysis and Countermeasure to Over-Hot Failure for the Generator Encourage Extremity;
发电机励侧端部压圈过热故障的分析
13.
Treatment to insulating leakage at stator end of 150 MW hydraulic generator
150MW水轮发电机定子端部绝缘泄漏处理
14.
Detection of Hidden Generator Insulation Problems through Measurement of End Potential
端部电位测量法检测发电机绝缘隐患分析
15.
Renewal and Transformation of Bearing Sealing Cover on Yantan Hydropower Co. Ltd.
岩滩发电公司机组轴承密封盖更新改造
16.
Influence of Strain Electrical Measuring Method to Engine Jar Cover Temperature,Stress Measurement System
应变电测法对发动机缸盖测试系统的影响
17.
Research of a Lithium Battery Fully Automatic Bending Ears Capping Machine
锂电池全自动极耳折弯封盖机系统开发
18.
Remove lower generator mounting bolt and remove generator/vacuum pump from vehicle.
拆去下端发电机安置螺栓，并从汽车上拆去发电机/真空泵。