1.
Research on the dynamic model of an elastic rotation shaft with two end faces in relation rotation
二端面弹性转轴相对转动动力学模型研究
2.
A similarity dynamics equation and a relative dynamics equation of an elastic rotation shaft with twin sides based on the theory of relativity are built in this paper.
基于相对论性原理建立了二端面弹性转轴的动力学方程、对动力学方程及相似动力学方程。
3.
Axial Rotation Symmetry of Third-Order Nonlinear Elasticity of Crystals;
晶体三阶非线性弹性的轴转动对称性
4.
Development of Elastic Couoling Torsional Vibration Test System
弹性联轴器扭转振动测试系统的研制
5.
Effect of the Axle Box Rotary Arm Positioning Mode on Resilient Nodal Points
轴箱转臂定位方式对弹性节点的影响
6.
Nonlinear Dynamical Behaviors and Control of a Journal Bearing-Flexible Rotor System;
弹性转子—轴承系统非线性动力学行为及控制
7.
ELASTIC FLEXURAL-TORSIONAL BUCKLING BEHAVIOR OF PRE-TWISTED BAR UNDER AXIAL PRESSURE
初始扭转轴压杆弹性弯扭屈曲性能研究
8.
Detective Performance of the Short Circuit Electrostatic Detector Oriented Perpendicular to the Rotating Projectile Longitudinal Axis
旋转弹丸短路轴向式静电探测器探测性能
9.
Study on Torsional Vibration of Bulldozer Drive System by Elastic Coupling;
采用弹性联轴节的推土机传动轴系扭转振动分析
10.
Vibration Characteristics of Jeffcott Rotor System Supported by Cylindrical Roller Bearings
圆柱滚子轴承若干参数对弹性转子系统临界转速的影响
11.
Dynamic characteristics of rub-impact of dual-disc rotor system on flexible casing-rolling bearing supports
弹性机匣-滚动轴承双盘碰摩转子系统动力学特性
12.
Circlips for shaft--Type A
GB/T894.1-1986轴用弹性挡圈--A型
13.
Elastic pin coupling
GB/T5014-1985弹性柱销联轴器
14.
AN ELASTOPLASTIC CONSTITUTIVE MODEL OF SANDS CONSIDERING CYCLIC ROTATION OF PRINCIPAL STRESS AXES
考虑应力主轴循环旋转效应的砂土弹塑性本构模型
15.
The Simulation Analysis of Axial Force of the Highly Flexible Coupling's Rubber Element
高弹性联轴器橡胶弹性元件轴向力仿真分析
16.
If this load centroid is behind the elastic axis of the wing structure, then a nose-down twist of the main wing surface results.
如果该载荷重心在机翼结构弹性轴之后，则引起主机翼表面前端向下的扭转。
17.
Elastohydrodynamic Lubrication Analysis of Crankshaft Bearing Considering Crankshaft Deformation under Load and Roughness Surface;
计入曲轴受载变形的粗糙表面曲轴轴承弹性流体动力润滑分析
18.
Thermohydrodynamic Lubrication Analysis of Crankshaft Bearing Considering Crankshaft Deformation under Load;
计及曲轴受载变形的曲轴轴承热弹性流体动力润滑分析