1.
Improvement of inlet throttle velocity regulator in lathe hydraulics system;
机床液压系统中进口节流调速回路的改进措施
2.
The Effect of the Variable Load on the Pressure of the Hydraulic Cylinder in the Entrance Throttle Governing System;
进口节流调速系统负载变化对液压缸压力的影响
3.
Further opening the throttle valve activated the main fuel jet.
当节流阀进一步打开时,主喷口开始工作。
4.
Large Size Mixed Flow Pump with Characteristic Control by Means of Adjustable Inlet Guide Vane
用可调进口导叶调节特性的大型混流泵
5.
Carefully clear inlet piping system of foreign matter and mount regulator with the flow arrow pointing in the direction of flow.
小心清洗进口管道系统的外来物质，安装调节阀时要使得水流箭头指向水流方向。
6.
When our government begins to do it, it should provide its support in three stages: “headwaters, stream and outflow”.
政府在促进它们的结合时，需要从“源、流、出口”三个环节运用适当的财税政策进行支持。
7.
Study on dynamic characteristics of metering-out control system of series-connecting throttle valve on the return oil-line
节流阀出口节流调速系统动态特性研究
8.
The flowrate through the wellhead choke is relate to the wellhead pressure, the flow velocity of oil and gas, construction of choke.
井口节流器的流量与油井压力、气流速度和节流器的结构有关。
9.
Reduced pressure near the partially closed throttle valve caused the fuel to flow from the idling jet into the intake air.
由于部分关闭的节流阀附近的压力下降,燃油由怠速喷口喷入吸进的空气。
10.
A butterfly isolation valve cannot be installed directly to the valve inlet flange, as the disc will contact the orifice plate.
蝶阀隔离阀不能够直接安装在阀门进口法兰上，因为其阀瓣将会接触到节流板。
11.
Mount restrictor bar into the restrictor bar groove of upper die, mount adjusting bolt for restrictor bar into the bolt hole in the restrictor bar, then mount lower press block, upper press block.
在上模节流棒槽内装入节流棒，将节流棒调节螺栓装配进节流棒的螺丝孔中，再装配上压块。
12.
Study on Water Hydraulic Throttle Valve and Anti-cavitation Characteristics of Orifices;
纯水液压节流阀及阀口气蚀分离研究
13.
An Analysis of Floating Population s Contraception and Its Influencing Factors;
流动人口的避孕节育及影响因素分析
14.
Remove the air inlet hose from the throttle body and air cleaner.
从节流阀体和空气滤清器上拆下气流入口软管。
15.
The velocity in the intake is not equal to the stream velocity.
进口的流速不等于河水流速。
16.
Install throttle body to intake manifolRefer to Throttle Body installation in this section of the group.
在进气歧管上安装节流阀体。请参阅单元中本节的节流阀安装部分。
17.
Energy-saving improvement of the import semi-autogenous mill with size φ8.35 m×3.96 m
进口φ8.35m×3.96m半自磨机节能改造
18.
On Detailed Design of the Pass in and out Openings of Non-excavation Construction Pipeline
非开挖施工管道进出洞口的细节设计