1.
Defining Minimum Base Radius of Plate Cam for Oscillating Follower by 0.618 Optimization Method
0.618法最优确定盘状摆动凸轮机构的最小基圆半径
2.
DETERMING THE MINIMAL RADIUS OF BASE CIRCLE OF A CAM WITH TRANSLETINGA POINT FOLLOWER ACCORING TO THE ALLOWABLE PRESSURE ANGLE[α]
按许用压力角(α)确定直动从动件盘形凸轮机构凸轮最小基圆半径
3.
Research on Method to Confirm Minimum Radius of Circular Curve of Mountain Expressway;
山区高速公路圆曲线最小半径确定方法的研究
4.
Mathematic calculation approach of minimum bending radius of mandrel based on Matlab
基于Matlab的芯轴最小弯曲半径计算
5.
A Study of Burr Fillister Sizes as well as the Minimum Fillet Radius of a Final Forging Die with the Finite Element Method
毛边槽尺寸与终锻模最小圆角半径的有限元法研究
6.
minimum digging radius at floor level
停机面最小挖掘半径
7.
Calculation of Pressure Angle and Minimun Average Cylinder Radius of Cylindrical Cam Mechanisms with Oscillating Roller Follower by Using Instantaneous-center Method
用瞬心法求滚子摆动从动件圆柱凸轮机构压力角和最小平均圆柱半径
8.
Clustering Algorithm Based on Residual Energy and Least Adjacent Clustering Radius
基于剩余能量与最小邻近簇半径的成簇算法
9.
double radius button head snap
双半径半圆头铆钉窝子
10.
The maximum shearing stress to which the material is subjected has a value equal to the radius of the circle.
材料承受的最大应力数值等于圆的半径。
11.
The first order forbidden energy?band width is the biggest when cylindrical radius is about 40 ?.
圆柱半径在40 左右时,第一禁带宽度最大。
12.
Rod: round sections smaller than round bars, up to about 10mm in diameter.
细棒材--横断面为圆形，比圆棒材小，最大直径约l0mm。
13.
Bohr radius was the radius of the circle in which the electron moved in the ground state of the hydrogen atom, according to the Bohr theory.
根据玻尔理论，玻尔半径是在基态氢原子中电子运动的圆周半径。
14.
Measurement of short arc based on centre constraint least-square circle fitting
基于圆心约束最小二乘圆拟合的短圆弧测量
15.
Study on the Minimum Value of Curve Radius in Shield Construction;
盾构法施工最小曲线半径取值的研究
16.
The Ordering of the Connected Graphs with the Smallest Laplacian Spectral Radii;
连通图的最小Laplace谱半径的排序
17.
The Research of Lowest Radius to High-Speed Railways with Ballastless Tracks;
无碴轨道高速铁路最小曲线半径研究
18.
A Reasonsbale Methord to Decide the Basic Circle s Radius Of the Cam;
一种合理确定凸轮机构基圆半径的方法