1.
container, flexible, intermediate bulk, of polypropylene or polyethylene woven fabrics
中等厚度软质包皮,聚丙烯或聚乙烯织物制成
2.
The Bending of Isotropic Shellow Spherical Shell Supported by Corner Colums of Panels with Uniform Thickness;
角点支承的等厚度各向同性球面扁壳的弯曲
3.
High strength performance： the anti-striking force of tempered glass of the same thickness is3-5 times than that of the common glass.
高强度：同等厚度的钢化玻璃抗冲击强度是普通玻璃的3-5倍，抗弯强度是普通玻璃的2~倍。
4.
Analysis of Uncertainty of Non-Weighted Measurement In Uniform Thickness Interference
等厚干涉中非等精度测量的不确定度分析
5.
The opening displacement V is equal to the thickness contraction W.
张开位移V等于厚度的收缩量W。
6.
These cyclic sequences are overlain by the lagoon dolomitic mudstones and shales.
米级旋回层序之顶覆以厚度不等的?
7.
Used to measure thickness of various kinds of woven and knitting goods.
用于测量各种织物、革、料、毯、张等的厚度及均匀度。
8.
Determination of Curing Temperature and EV Time for Thick walled Rubber Article
橡胶厚制品硫化温度与等效硫化时间的测定
9.
Study on the Process Parameters Control of Plasma Arc Cutting Variable-thickness Plates;
等离子体弧变厚度切割工艺参数控制研究
10.
Characteristic Analysis of Ice Accumulation on Transmission Lines and Simulation Based on ANN Model over China
全国电线结冰厚度分布及等级预报模型
11.
In- situ hollow floor hollow cylinder transverse direction equivalent thickness simplified numerical solution
现浇空心楼板横筒方向等效厚度简化数值解法
12.
Relationship Between Properties and Thickness of Plasma Sprayed NiCrAl Coatings
等离子喷涂NiCrAl涂层性能与厚度关系研究
13.
The relationship can be expressed by a linear equation of winding length and thickness versus drape behavior.
织物弯曲长度、厚度等与织物悬垂性可以线性方程表达。
14.
Shell-thickness Calculation of SPV's Structures in Strength Equivalent Design by Using the High Strength Steel
专用车构件高强度钢板强度等代设计中的板厚计算
15.
cm in thickness/a thickness of cm
厚4 厘米[4 厘米的厚度]
16.
The puddle section for heavy duty batteries must be at least the thickness of the base of the poststrap.
重型汽车蓄电池极柱焊接部位至少要等于极柱底座的厚度。
17.
Metallic materials-Reverse bend test(Sheet and strip 3mm thick or less)
GB/T235-1988金属反复弯曲试验方法(厚度等于或小于3mm薄板及带材)
18.
The method also permits inverse design with flaps, specification of geometric constraints (thickness, camber, etc.).
办法还允许逆向设计皮瓣、几何约束规格(厚度、拱等).