1.
Crank Position Sensor Sig
曲轴位置感知器信号
2.
Supplies the required 5 volt power source to the crankshaft position sensor, camshaft position sensor, MAP sensor and throttle position sensor.
向曲轴位置感应器、凸轮轴位置感应器、MAP感应器以及节气阀位置感应器提供所需的5伏电压。
3.
CRANKSHAFT POSITION SENSOR—V-8 ENGINES
曲轴位置感知器—2公升/9公升 V-8 引擎
4.
Crankshaft Position Sensor Principle and Diagnosis of Shanghai Buick Engine;
上海别克发动机曲轴位置传感器原理及检测
5.
Design of Signal Simulator for Crankshaft Position Sensor
基于CPLD的曲轴位置传感器信号仿真器设计
6.
A Crankshaft Fluctuation Sensor (CKF) is located near the bottom of the timing cover where it generates a signal as the crankshaft timing chain sprocket rotates past it.
曲轴位置传感器安装在定时器壳底部附近，产生一个曲轴定时链轮齿通过的信号。
7.
Crankshaft Journal Size Paint Location
曲轴颈部尺寸标记位置
8.
The crank is an offset section of the crankshaft.
曲柄是曲轴的偏置部分。
9.
closed crankcase ventilating system
闭式曲轴箱通风装置
10.
The four places in the automobile from which pollutants can escape are the fuel tank, carburetor, crankcase and tail pipe.
汽车内泄漏污染物的四个位置是燃油箱、化油箱、曲轴箱和尾管。
11.
The maximum amount of oil is reached when marker dot A is brought to the position just opposite from the needle bar crank 3 by turning the adjust pin in direction C.
从图上所示的位置向C方向转动，当转到与针杆曲轴3的正对面的位置时，油量为最大。
12.
Create a Position Key on
创建Y轴位置关键帧
13.
Create a Position Key on X
创建X轴位置关键帧
14.
Create a Position Key on Z
创建Z轴位置关键帧
15.
Delete a Position Key on
在Y轴删除位置关键帧
16.
Delete a Position Key on Z
在Z轴删除位置关键帧
17.
Delete a Position Key on X
在X轴删除位置关键帧
18.
The Perpendicular Collision of a Particle and a Homogeneous Bar;
小球与轴线位置可变定轴杆垂直碰撞