1.
The Experimental Research on High-Speed Machining Surface Quality of Aluminum Alloy Holes
铝合金连杆大端孔高速切削表面质量的试验
2.
The main bearing journals fit into the cylinder block and the big end journals align with the connecting rods.
主要轴承曲颈安装在气缸体和与连杆大头末端匹配的曲颈上。
3.
If the end of the link which does vertical translation is connect with the other links.
杆子的尾端连接著另一个杆子，做上下移动。
4.
The throw of the crankshaft, i.e. the distance between the main journal and the big end centers, controls the length of the stroke.
曲轴的摆幅，即在主要曲颈和连杆大头末端中心之间的距离，控制着冲程的行程。
5.
Powder Metallurgy Forging and Cleavaging Technics for Conn-Rod
连杆粉末冶金锻造与连杆大头劈裂技术
6.
A lower, rearward surface, as of the head of a golf club where it joins the shaft.
尾端部位高尔夫球棍头上和杆相连的弯头
7.
The piston end of the rod is attached to the piston by the piston pin, or wrist pin.
连杆的活塞端用活塞销或销轴安装在活塞上。
8.
"The horizontal pieces forming the top and bottom of the truss are called the chords, and the sloping and vertical pieces connecting the chords are collectively called the web."
顶端和底部水平面上的桁架通常被称为弦杆,而斜面或垂直方向上连接弦杆的则被称为腹杆。
9.
"The cylinder of an internal-combustion engine is closed at one end by a plate called the head and open at the other end to permit free oscillation of the connecting rod, which joins the piston to the crankshaft."
内燃机的汽缸在一端用盖封住,叫做头,另一端敞开,使连接活塞和曲轴的连杆能自由摆动。
10.
The crank end of the connecting rod is sometimes called the rod "big end".
连杆的曲轴有时称为“大头”。
11.
The linkage rides to the end of the slot with enough force to break the choke valve away from the full-choke position.
连杆移动至槽的一端，用足够的力推动阻风门全部离开全阻风位置。
12.
Active Control for Two-Link Flexible Manipulator with Tip Mass
带有末端集中质量的双连杆柔性机械臂主动控制
13.
The terminal server has exceeded the maximum number of allowed connections.
终端服务器超出了最大允许连接数。
14.
This lane rejoins the main road further on.
这条小巷前端与大路相连.
15.
Yankee Dryer End Covers Compensated with Sleeved Bar Analysis of Working Stress
大烘缸端盖用套筒拉杆补偿——工作应力分析
16.
"The cylinder of a steam engine is closed by plates at Both ends, with provision for the piston rod, which is rigidly attached to the piston, to pass through one of the end cover plates."
蒸汽机的汽缸两端都用盖封住,使得与活塞刚性连接的活塞杆穿过盖的一端。
17.
Connect the temperature control cable core end to the temperature control lever on the back of the heater-A/C control.
在取暖器-空调控制后部上连接温度控制电缆核末端至温度控制连杆。
18.
A rod or lever transmitting motion in a machine.
连杆机器中传递运动的连杆或杠杆