1.
Retrofit of the Low-pressure Shaft Butt Seal in 51-50-3 Type Steam Turbine
51-50-3型汽轮机低压轴端汽封的改造
2.
Analysis on Energy-saving Modification of Shaft Seal of 300MW Steam Turbine
300MW汽轮机轴端汽封改造后节能效果分析
3.
ANALYSIS AND IMPROVEMENT OF SEALING WATER LEAKAGE PROBLEM FROM SHAFT END OF STEAM-DRIVEN FEED-WATER PUMP OF SUPERCRITICAL 600 MW UNIT
超临界600MW机组汽动给水泵轴端密封漏水问题的分析与改进
4.
axial double mechanical seal
轴向双端面机械密封
5.
"The cylinder of an internal-combustion engine is closed at one end by a plate called the head and open at the other end to permit free oscillation of the connecting rod, which joins the piston to the crankshaft."
内燃机的汽缸在一端用盖封住,叫做头,另一端敞开,使连接活塞和曲轴的连杆能自由摆动。
6.
Improvement on Leakage of Axial Sealing of Steam Turbine
B6-3.43/0.981型背压汽轮机轴封漏汽的治理
7.
Reconstruction of Shaft End Air Seal for C(M) 630 Gas Blower
C(M)630型煤气鼓风机轴端气封改造
8.
Transformation of Axis Seal and Oil Files of N 25-35-1 Gas Turbine;
N25-35-1型汽轮机组高低压轴封轴承油档改造
9.
Renovation of Shaft Seal System of 220MW Turbo-generator Set
220MW汽轮发电机组轴封系统改造
10.
The bottom bearing applies both labyrinth seal and frame seal, which have good performance of sealing. The main shaft is anticorrosive.
下轴承端盖密封采用双重密封，可确保密封效果，主轴采用防腐新技术，能保护主轴免受腐蚀。
11.
Permanently sealed and lubricated ball bearings front and rear.
前后端盖装有永久密封和自润滑的滚珠轴承。
12.
Research on Condition Monitoring and Fault Diagnosis Technique for Asynchronous Motor
富气压缩机轴端干气密封的研究与应用
13.
Structure and design of new ship stern shaft sealing device
新型船舶艉轴端面密封装置的结构与设计
14.
On the exploration in the peddler's spindle fluctuating oil-covered device
搅拌机轴端浮动油封装置设计制造研讨
15.
The Calculation and Error Analysis for HP-IP Midspan Packing Leakage in Steam Turbines
高中压合缸分隔轴封漏汽计算方法与误差分析
16.
Reason analysis of gland seal pipeline vibration for 600MW turbine and its improvement
600MW汽轮机轴封管路振动的原因分析与改进措施
17.
An axial symmetrical model is set up for the sealing structure of the bulkhead plate for a columniform dewar.
建立了针对柱形真空杜瓦容器端盖密封结构的轴对称模型。
18.
"The cylinder of a steam engine is closed by plates at Both ends, with provision for the piston rod, which is rigidly attached to the piston, to pass through one of the end cover plates."
蒸汽机的汽缸两端都用盖封住,使得与活塞刚性连接的活塞杆穿过盖的一端。