1.
The characteristic of the temperature stress in the jointless switch lies in supporting additional temperature stress on the stock rail, the stress and the displacement presents the complex nature.
无缝道岔温度力的特点在于基本轨要承受附加温度力的作用,岔内钢轨受力和位移状况复杂。
2.
Additional Strain Variation Law of Mine Shaft Lining under Joint Effect of Additional Force and Temperature
附加力和温度共同作用下井壁附加应变变化规律
3.
Finite Element Analysis of the Temperature Stress on the Jointless Switch under Multi-working Conditions
多种工况下无缝道岔温度附加力的有限元分析
4.
Study on temperature additional error of LSIII flange transmitter
初探法兰变送器温度附加误差的计算
5.
effect of high temperature on the tolerance of acceleration
高温对加速度耐力影响
6.
Thermal Stresses of Asphalt Overlay on Cement Concrete Pavement (Ⅰ):Mechanistic Models
沥青加铺层温度应力研究(Ⅰ):力学模型
7.
additional manual reset hi limit - requires heater to be manually reset upon over-temperature condition.
附加人工预置高温限制---用于人工设置热水器的最高温度限制。
8.
STRESS-STRAIN BEHAVIORS AROUND THE YIELD STRENGTH IN SEQUENTIAL ROOM TEMPERATURE CREEP TESTS
相续室温蠕变中屈服强度附近的应力应变行为
9.
er with etched stem
附有刻度的玻璃温度计
10.
The effects of the additive concentration, temperature and rotation speed of the electrode on the coexisting adsorption states are also discussed.
研究了添加剂浓度、镀液温度和电极转速对并存吸附状态的影响。
11.
A rise in temperature will send up the pressure inside the casing.
温度的升高会使盒内的压力加大。
12.
Both the maximum absorption capacity and absorption strength are increased with temperature rising.
温度的升高，不但会使最大吸附量增大，而且增加土壤对锌的吸附强度
13.
Temperature Dependence of Additional Peaks Characteristics of Single Mode Silica Fiber Stimulated Raman Scattering
温度变化对单模石英光纤受激拉曼散射附加峰的影响
14.
A DIRECT MODEL UPDATING METHOD USING ADDED KNOWN STIFFNESS
基于附加已知刚度的动力学模型修正方法
15.
Effects of sodium hyaluronate on the physicochemical properties of ophthalmic thermosensitive in situ ge1s of diclofenac sodium
透明质酸钠对眼用温度敏感原位凝胶体外释放和粘附力的影响
16.
THE THERMODYNAMIC TREATMENT OF THE CRYO SORPTION PROCESS IN A CRYOPUMP
低温泵中低温吸附过程的热力学处理
17.
Shrinkage stress was found to increase linearly with cure temperature.
我们发现收缩应力随固化温度直线增加。
18.
SOFTWARE REALIZATION OF PRESSURE AND TEMPERATURE CONTROL ON GAS HEATING FURNACE FOR FORGING
锻造煤气加热炉压力及温度控制软件的实现