说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 句库 -> 主销轴线
1.
The Calculation of the Angle and Position of the Kingpin Axis Based on Steering Geometric Test
基于转向几何试验的主销轴线角度和位置的解算
2.
As the crankshaft rotates, the crankpin swings in a circle around the shaft.
随着曲轴的转动,曲柄销绕主轴作圆周摆动。
3.
Failure Analysis on Outside Left Main Pin Hole of Vehicle Front Axle
汽车前轴左主销孔外侧断裂失效分析
4.
Adds or deletes major category axis gridlines
添加或删除垂直(主要分类轴)网格线
5.
Adds or deletes major value axis gridlines
添加或删除水平(主要数值轴)网格线
6.
Value Axis Gridlines Button\\015\\015Adds or deletes major gridlines for the value axis.
添加或删除数值轴的主要网格线。
7.
Category Axis Gridlines Button\\015\\015Adds or deletes major gridlines for the category axis.
添加或删除分类轴的主要网格线。
8.
distance from spindle nose to central line of table
主轴端面至工作台中心线距离
9.
Research on the Online Dynamic Balance Technical for the High-speed Spindle;
高速电主轴在线动平衡补偿技术研究
10.
A Discussion on the Main Axis Analysis Method Modeling of the Conic;
二次曲线主轴方程的解析法建模研讨
11.
Study on the nonlinear dynamic rigidity characteristics of the initiative magnetic bearings
主动磁力轴承非线性动刚度特性研究
12.
Research for Speed Control of Motorized Spindle Based on On-line Parameters Estimation
参数在线估计的电主轴调速系统研究
13.
Design and Calculation of Main Shaft for Uncoiler of Coating Test Line
涂层试验线开卷机主轴的设计与计算
14.
crankshaft (main journal turning lathe)
曲轴(主轴颈)车床
15.
upper center crankshaft bearing
曲轴主轴承上中轴瓦
16.
Adjust the amount of oil supplied to the thread take up and needle bar crank 3 by turning adjust pin 4.
调整挑线杆和针杆曲轴部3的油量时,转动油量调整销4进行调整。
17.
The trait of the technics technique and equipment consists in the principal axis of grinding head and the axes of workpiece perpendicular disposal.
本工艺和设备的突出特点在于磨头主轴与工件轴线呈垂直布置。
18.
The main parts in the upper structure that bear pressure are of pipe truss structure and pin shaft link.
本机上部结构的主要受压构件为管绗结构,销轴连接。